5. ACCESSORY CONNECTOR'S
2 Pin Valet/Program/Override
The BLACK and GREY twin lead wires loaded in the two pin blue connector are the ground supply and program/valet/override input of the Remote Start. Drill a 9/32" hole and mount this switch in an easily accessible location under the driver's dashboard.
4 Pin Antenna/Receiver Connector: (Black Connector)
Mount the supplied antenna/receiver to a clear spot on the vehicle's winshield that will not block the driver's vision. A good location is usually high on the winshield near the rear view mirror. Be carefule not to mount the antenna/receiver on any metallic window film, as this will effect system range. Route the antenna/receiver cable to the control module and plug into the 4 pin black connector.
4 Pin 2nd Shock Sensor Port: (White Connector)
The RED (+12 volt), BLACK (ground), BLUE
2 Pin LED Harness: (White Connector)
The RED & BLUE wires loaded into the two pin mini white connector control the anode and cathode of the dash mounted LED. Drill a 1/4" hole and mount the LED in an easy to see location on the dashboard. Be careful to check to make sure that there is enough clearence behind the panel you are drilling into.
6.SYSTEM POWER-UP PROCEDURE
1.After all connnections are complete, turn the vehicle's ignition key to the ON position.
2.Insert the 30 Amp fuse into the fuseholder.
3.Turn the ignition key to the OFF position.