Soundstream Technologies CA 160 installation instructions Diagram

Page 17

4. DOOR LOCKS

Negative Lock Output / Positive Unlock Output (GREEN)

Negative Unlock Output / Positive Lock Output (BLUE)

Negative Second Door Unlock Output (BLUE/GREEN)

Reverse Polarity (5-Wire Doorlocks) and Reverse Polarity with 2-step Unlock:

All Door Lock and Unlock: Locate the lock / unlock wire at the vehicle’s lock / unlock switch.

Verification: These wires will rest at ground and register positive voltage when the Lock and Unlock switches are activated.

Driver’s Door Unlock: Locate the unlock motor wire directly from the actuator inside the driver’s door.

Verification: This wire will rest at ground and register positive voltage when the driver’s door is unlocked.

Connect the GREEN and BLUE or BLUE/GREEN wires shown in diagram 10 below. Use (1) Code Alarm part DLRK (Door Lock Relay Kit, not supplied) or (2) Code Alarm part HDRLY (SPDT relay, not supplied).

Note: When adding the 2 step unlock feature the BLUE/GREEN 2nd door unlock wire will be used to unlock all vehicle doors on the second press of unlock. An additional SPDT relay (not supplied) (Code Alarm part HDRLY) is required. Connect the relays as shown in diagram 11 to unlock the driver’s door on the first press of unlock

Diagram 10

Master Door Lock Switch

86

87

87a

30

Fused +12 Volt

Battery Source

GREEN (-) Lock Output

85

Lock X Cut

Unlock

87

Fused +12 Volt Battery Source

To Door Lock

Actuators

 

87a

BLUE (-) Unlock Output

 

Or BLUE/GREEN(-) 2nd

86

85

Door Unlock Output

 

30

 

 

X

To Door Lock

 

Actuators

 

Cut

 

 

 

Diagram 11

Fused +12 Volt

 

 

Battery Source

87

 

 

 

 

87a

BLUE (-) Unlock Output

 

86

85

 

30

 

From Keyless Entry

 

To Unlock Side Of

Module Or Door

X

Driver's Door Actuator

Lock/Unlock Relays

CUT

 

 

 

Image 17
Contents For Authorized Dealers 800 CA 160 Installation InstructionsCA-160 System Layout CA- 160 System Layout Pin Power Harness RF Programmer Manual Feature ProgrammingUsing the M1 function Selecting Programmable FeaturesCA 160 Programming Guide Transmitter Programming 3 Chirps Setup & ProgrammingRF Programmer Receive 4 Chirps Shock Sensor Programming 5 ChirpsVolts Ignition Input/Output Pink PIN Main Power HarnessBattery Power RED Dome Light Supervision Output +/- BLACK/WHITE Basic Installation 22 PIN Base HarnessNegative Door Input Green Positive Door Input PurplePIN Base Harness Ground When Armed Output OrangeHeadlight Output LT. GREEN/ORANGE Hood Pin Input GrayParking Light Output +/- White Instant Trigger Input BLUE/WHITESiren Output + Brown Song Bird Output BROWN/WHITE SB1 Accessory required Unlock Switch Sense LT. BLUE/GREENTrunk Pin Switch Input Blue Manual ARM input LT. BLUE/REDChannel 2 PINK/BLACK PIN Advance Channel HarnessChannel 3 PINK/GREEN Channel 4 PINK/BLUEDoor Locks DiagramFused +12 Volt Battery Source Door Lock Switch Diagram Fused +12 Volt Battery Source Green Lock Output Door Lock Switch Adding Aftermarket Actuators System POWER-UP Procedure Accessory ConnectorsSecurity Operation Press Lock once Pre-arm modeIf the above conditions are not present If door, sensor, hood/trunk or ignition input is triggeredPress Disarm twice Press DisarmPress Find Press and hold Panic for 2 seconds