Clarion VRX815 Removing the Main Unit, Spring into hole a of the hook plate, then pull

6. REMOVING THE MAIN UNIT

1.	When the rear of the main unit has been se-	the main unit out by the hook plate. (Insert both
	cured with the method shown in Figure 6 un-	the right and left edges of the hook plate.) (Fig-
	fasten the special screw.	ure 9)
2.	Remove the outer escutcheon.
3.	Insert the hook plate between the spring and	Note: Keep the hook plate. You cannot remove the
	the universal mounting bracket, fit tab Bof the	main unit without disengaging the hook plate.
	spring into hole A of the hook plate, then pull

Universal mounting bracket	Instrument panel
2-Hook plate
	Main
	Unit
	Spring

Outer escutcheon

A B

Figure 9

Installation and Wire English connection manual

7. CAUTIONS ON WIRING

1.Be sure to turn the power off before wiring.

2.Be particularly careful where you route the wires.

Keep them well away from the engine, and exhaust pipe, etc. Heat may damage the wires.

3.If the fuse should blow, check to see if the wir- ing is correct.

If it is, replace the fuse with a new one with the same amperage rating as the original.

4.When any fuse is to be replaced, pull out the fuse (15A) at the rear of the tuner amp unit and put in a new one (Fig.10).

Rear view of the tuner amp unit

Fuse (15A)

Figure 10

CAUTION

After the connection, fix the lead by a clamp or insulation tape for protection.

5.To replace the fuse, release the catch on the main unit side, remove the old fuse and insert the new one. (Figure 11)

Note: There are various types of fuse holder. Do not let the battery side touch other metal parts.

Fuse

Fuse holder

Figure 11

VRX815 51