Integra DSR-7.3 instruction manual From the connecting block Mini plug cable

Operating Components not Reached by the Remote Controller Signals (IR IN)

In order to use the remote controller to control the DVD Receiver from a remote location, you will need to prepare a multi-room kit (sold seperately) such as one if those given below:

•Onkyo’s Multi-Room System kits (IR Remote Controller Extension System), or

•Multiroom A/V distribution and control systems from Niles® and Xantech® to name a few.

From the connecting block

Mini plug cable

L

PREOUT				IR
AUDIO
			REMOTE	IN
			CONTROL
			R
SUB	IN	OUT	IN
WOOFER	TV/LINE	MD/CDR/TAPE
DIGITAL			VIDEO OUTPUT

YPBPR

OPTICAL

OUT IN S VIDEO VIDEO COMPONENT

	ANTENNA
AM	FM 75

SURROUND		FRONT SPEAKERS
SPEAKERS					AC INLET
R	L	R	CENTER	L

If the remote controller signal does not reach the DVD Receiver

If the DVD Receiver is located inside a cabinet or other enclosure where the infrared rays from the remote controller cannot enter, then operation with the remote controller will not be possible. In such a case, it will be necessary to install a remote sensor at a location outside of the cabinet for the infrared rays from the controller to reach.

The IR IN input allows you to control the DVD Receiver from the remote zone with the remote controller even though the remote zone may be on the other side of the building from the main zone. The diagram below shows how to make the prober connections for the remote zone.

to IR IN

IR IN

DSR-7.3

In the cabinet

Connecting	IR Receiver
block

Remote Controller

IR Receiver

DSR-7.3

Connecting block

Remote Controller

Main room Remote zone

: Signal flow

: Signal flow

21