Integra DSR-7.3 instruction manual Programming Video CDs, CDs, To save a program in memory

Before operating the remote controller

Press Mode DVD.

VCD CD

7

Program

Number buttons

		Sen d
			S
se		On	tandby
n/Clo
Ope					Light
		Input	l
			Se ector		2
		Mode
		Recvr	Tape
DVD					TV
	Dimmer		Display
ep					Clo
Sle					ck
		Menu	Men	u
	Top
Step/Slow
CH		ENTER			VOL
Tun
	R	eturn	etup t
T-D/ST			TSVInpu		Muting
Surround			A.Control
Repeat					A-B
Late Night					Timer
Audio		Angle	Subtitle		FM Mode
Last M	Program		Random		Clear

SP Setup	Test Tone	CH Sel
1	2	3
SW Mode	Distance
4	5	6
IPM	T-D Setup	Up/Down
7	8	9
+10	0	Search
-- / ---		Enter
	RC-507M

2/3/5/∞

ENTER

£

Clear

■To save a program in memory

This DVD Receiver can memorize the programs on up to 24 DVDs. By turning the [Program Memory] to [On], the DVD Receiver will save your program and recall it the next time you use the same DVD. When the program memory exceeds 24, programs will be erased in chronological order from the oldest program in memory.

1Use the cursor button (∞) to highlight [Program Memory] and use the cursor button (3) to select [On].

Program Chapter Program Title

Current:	Title		7 Chapter 1
Title	1		(Chapter 1~18)
Program Memory		On
		Off
	Move	ENTER	Select PROGRAM Exit

Programming Video CDs, CDs

A program with a maximum of 24 steps can be memorized.

1	Press Program.
	Program
	The program screen appears. When a
	Video CD or CD is loaded, the cursor
	appears in the program window.
	Program Track
	Current: Track	1(/10)
	Total Time	0.00

Move ENTER Play PROGRAM Exit

2Press ENTER.

The program is saved in memory.

Note

When a DVD with a program stored in memory is loaded, program playback may start automatically.

■To erase a program saved in memory

The DVD receiver erases programs in chronological order when the maximum number of programs that can be held in memory is

2

SP Setup	Test Tone
1	2
SW Mode	Distance
4	5
IPM	T-D Setup
7	8
+10	0
-- / ---

CH Sel

3

6

Up/Down

9

Use the number buttons to enter the numbers of the tracks in the order you want to program them in.

•To program tracks 9, 7, and 18 in order, press 9, 7, +10 and 8.

•To edit the program, refer to the procedures on the previous page.

exceeded. To prevent the DVD receiver from erasing older programs that you may still use regularly, or when you don’t want to use a program anymore, it is possible to manually erase programs stored in memory.

1Load a DVD that has a program stored in memory.

2Press Program.

The program screen appears.

3Use the cursor button (∞) to highlight [Program Memory] and use the cursor buttons (3/∞) to select [Off].

4Press ENTER.

The program is cleared from memory.

If you press Clear in stop mode, the program will be cleared from memory and [Program Memory] will be turned to [Off].

3		Press ENTER or £.
		• Playback starts in the specified track
	ENTER	order.

• Press PROGRAM to return to the previous display. The program play will not begin until £ is pressed.

• To stop the program play, press 7.

Note

You cannot program when playing a Video CD using menu selections (during PBC).

57