Integra DSR-7.3 instruction manual Speaker Setup, Press SW Mode on the remote controller

Speaker Setup

		Sen d
		S
se	On	tandby
n/Clo
Ope			Light
		l
	Input Se ector		2
	Mode
	Recvr	Tape
DVD			TV
	Dimmer	Display
ep			Clo
Sle			ck

You need to set up the speaker configuration for the speaker system connected to the SPEAKERS connectors

(see page 17).

Notes

•Speaker setup cannot be done if;

– Headphones are connected (see page 40)

•It is not necessary to set the parameters again once you have completed the setup unless you change the speaker configuration.

Before operating the remote controller

Press Mode Recvr.

			Menu		Men	u
		Top
	Step/Slow
	CH			ENTER			VOL
	Tun
		R	eturn		etup t
	T-D/ST				TSVInpu		Muting
	Surround				A.Control
	Repeat						A-B
	Late Night						Timer
	Audio		Angle		Subtitle		FM Mode
	Last M	Program			Random		Clear
SP Setup	SP Setup			Test Tone			CH Sel
	1				2		3
	SW Mode			Distance
SW Mode	4				5		6
	IPM			T-D Setup Up/Down
	7				8		9
	+10				0		Search
	-- / ---						Enter

RC-507M

Selecting the number of speaker channels

Note

Selecting the Subwoofer mode

To check the present setting while the normal display is displayed, press SP Setup once. To change the setting, press the button repeatedly within three seconds.

Remote controller

only

SW Mode

4

Press SW Mode on the remote controller.

Remote controller

only

SP Setup

1

Press SP Setup repeatedly to select the number of channels for the SPEAKERS system.

Pressing the button repeatedly within three seconds changes the number of channels as follows (the corresponding speaker configuration is described in parentheses):

Speaker 5ch (Factory setting)

(Front left, center, and right, plus surround left and right speakers)

↓

Speaker 2ch

(Front left and right speakers)

↓

Speaker 3ch

(Front left, center, and right speakers)

↓

Speaker 4ch

(Front left and right, plus surround left and right speakers)

The normal display resumes in three seconds.

With the first press of the button, you can check the present setting. Then each press of the button changes the subwoofer mode as follows (a tip on how to select the right subwoofer mode is in parentheses):

SW Mode 1 (Factory setting) (When small–with limited bass signal handling–front speakers are connected)

↓

SW Mode 2

(When large–wideband–front speakers are connected)

↓

SW Mode 3

(When large–wideband speakers are connected to all channel)

↓

SW Off

(When no subwoofer is connected)

The normal display resumes in three seconds.

26