Integra DSR-7.3 Fine Focus, Contrast, Chroma Level, Hue, Memory Interlace Memory

Adjusting the Video Quality

<When set to [Interlace] in the Setup screen Video 1 menu.>

Fine Focus

Switch [On] to reveal greater detail (higher resolution) in the picture.

Contrast

Adjusts the contrast of the elements in the picture.

Sharpness

Adjusts the sharpness of the high-frequency (detailed) elements in the picture. (This setting is only effective when [Fine Focus] is [On].)

Chroma Level

Adjusts how saturated colours appear.

Hue

Adjusts the overall colour balance between red and green. (This is only effective when the DVD receiver is connected using the VIDEO OUT or S-VIDEO OUT jacks.)

Memory (Interlace Memory)

Programs the current settings.

5Use the cursor buttons (2/3) to adjust the settings.

Adjust these while a disc is playing to see the effect of changes immediately.

6Repeat steps 4 and 5 to make adjustments to other settings.

If you would like to save the settings in the DVD receiver’s memory, be sure to select either [1], [2], or [3] in the [Prog. Memory] or [Memory (Interlace Memory)] setting to establish which memory location to save the new settings in. Please note that if you select a location where settings have already been saved, the old settings will be replaced by the new ones.

Prog. Memory		Off	1	2 3
Move	ENTER Select		DISPLAY	Check

7When you are finished making adjustments, press ENTER to establish the new settings.

■Adjusting the picture quality settings

– To create your own setting (2)

1Use the cursor button (3) to select [Start] then press

ENTER.

Interlace Video Memory Select

Interlace Video Setup

2Use the cursor button (∞) to select [Video Setup] and press

ENTER.

3Press Display.

DNR		off				max
Sharpness			On		Off
Detail	min					max
Chroma Delay	min					max
Gamma	green					red
Memory		Off	1	2 3

4Use the cursor buttons (5/∞) to select the setting and use the cursor buttons (2/3) to adjust the settings.

Adjust these while a disc is playing to see the effect of changes immediately.

5To memorize the setting, select Memory 1, 2, 3, then press

ENTER.

The previous setting will be erased.

71