Toshiba E6580772 instruction manual Selection of encoder type, 100m

Page 19

E6580772

Caution in case of using open collector encoder connection

In case using pulse command oscillator and open collector encoder, the rise time of the voltage when the transistor is OFF tends to be longer than the fall time at the time when the transistor is ON. Therefore, if the maximum input frequency becomes higher, the pulse duty cannot maintain the 50±10% specification. Conduct derating on the maximum input frequency so that the pulse duty will be within the following specification range.

<Derating computation formulae of open collector’s maximum input pulse frequency >

0.8(Maximum input frequency x A) – Voltage rise time 3 x 10 –6…..

A : (single phase input: 2) (two-phase input: 4)

Voltage rise time Encoder exclusive pulse rise time + R x C

Encoder exclusive pulse rise time (s) : Please inquire at the encoder manufacturer.

R (Ω) (Input resistance)

: internal resistance 1000(Ω)external resistance value

 

 

(In case there is external resistance)

C(F) (Cable static capacity)

: Please inquire at the cable manufacturer.

<Example>

 

 

Encoder

: LBJ-005-500 (SUMTAK), 2-phase input

 

Encoder pulse rise time : 0.35 x 10-6(s)

Cable

: ROVV-SB-0.2-5P-10m (Furukawa Electric Co., Ltd)

 

Static capacity : 120 x 10 –12(F/m) x 10 (m)

From Formulae

0.8(Maximum input frequency x A) – Voltage rise time 3 x 10 –6Voltage rise time = (0.35 x 10 –6) + 1000 x (120 x 10-12x 10)

= 1.55 x 10-6

[Maximum input frequency] 87912 (Pulse/s) [Single phase input] 43956 (Pulse/s) [Two-phase input]

3.2.3 Selection of encoder type

The encoder type should be selected, following the table below.

Encoder Type

Characteristics

Maximum Wiring Length

 

Rated voltage output with emitter/follower

 

 

combination.

 

Complementary

High anti-nose characteristics. High-speed response.

100m

 

Long-distance transmission capability.

 

 

Need to pay attention to waveform irregularity.

 

 

The collector of the transistor is output directly.

 

Open Collector

Low anti-noise characteristics. Low-cost.

10m

Need to pay attention to waveform irregularity and

 

 

 

distortion.

 

18

Image 19
Contents E6580772③ Optional add-on cassette„ Transportation and Installation Safety Precautions„ Handling in general „ About operation „ Wiring„ About disposal of Inverter Introduction < Confirmation on accessories >< Type of F10M option unit > Contents Appearance Name and function of each sectionTLF001Z E6580772③ Name of each section terminalConnection to the inverter <When the unit is installed alone><When the unit is installed with another option> Connection to the inverter„ Connection with options „ PG interface TB2 terminal E6580772③ WiringF10M communication function Functional descriptionConnection of transmission cable Setting of communication parameters „ F10M communication parameters Communication parametersE6580772 ③ „ Other parameters E6580772③ Vector control with sensor PG input setting↑V a Connection of PGInverter 100m Selection of encoder typeBasic parameters Vector control setting parameterExtended Parameter Speed loop integration gain Speed loop ratio gainAccuracy of speed control Setting method for status monitoringSetting method for analog monitoring Monitoring method for feedback amountExternal diagram Environment Specification SpecificationPG feedback specification Specifications of transmission Warranty