Toshiba E6580772 instruction manual Communication parameters, „ F10M communication parameters

E6580772③

3.1.3 Communication parameters

„F10M communication parameters

Parameter name	Title	Setting value	Details
Inverter number	f802	0 to 255	Sets inverter station address. (Note 1)
			When using a message transmission, set the address of the
			master station to 0 and address of the inverter station to 1 or
			over.
Data type	f830	0, 1	Selects type of transmitting and receiving data.
selection			0: VFA7 mode
			1:μs250 mode
Input reference	f831	0 to 16	Sets scan transmission data to be received.
setting 1			0: Without setting
Input reference	f832		1: Command
setting 2			2: Speed reference value
Input reference	f833		3: Auxiliary speed reference value
setting 3			4: Torque limit value
Input reference	f834		5: Positive torque limit value
setting 4			6: Negative torque limit value
Input reference	f835		7: Torque command value
setting 5			8: Synchronized torque bias
Input reference	f836		9: Tension torque bias
			10: Load sharing gain
setting 6
			11: Drooping gain
			12: Speed loop proportional gain
			13: Speed loop accumulative gain
			14: Terminal output data
			15: Inertia moment ratio
			16: Expansion command
Monitor output	f841	0 to 16	Sets scan transmission data to be sent.
setting 1			0: Without setting
Monitor output	f842		1: Status
setting 2			2: Operation frequency
Monitor output	f843		3: Speed feedback value (real time)
setting 3			4: Speed feedback value (1-second filter)
Monitor output	f844		5: Internal torque reference value
setting 4			6: Output amperage
Monitor output	f845		7: Exciting amperage
setting 5			8: Torque amperage
Monitor output	f846		9: Overload accumulative value
			10: Deleted torque of acceleration/deceleration torque
setting 6
			11: Motor counter data
			12: Error code
			13: Input terminal data
			14: VI input
			15: RR input
			16: RX input

12