Novatel DL-V3 user manual Group Action, 119

The groupuse stop command interprets the group configuration as follows:

•The groupuse destination list is assembled, representing all destinations to be used by the group.

•For each destination in the groupuse destination list, an unlogall command is issued (for the particular virtual channel).

•If the groupuse destination list contains any FILE_n destinations, and a site has been defined, a site leave command is issued.

•For each FILE_n destination in the groupuse destination list, a logfile command is issued, terminating the associated destination with the logfile.

•groupposfix or groupposave configuration is executed.

1. An OK response to the groupuse command does not guarantee that all steps in the groupuse sequence have completed successfully.

2.A response to the groupuse command does not guarantee that the sequence has completed execution. If it is important to guarantee that a subsequent command is executed after the entire groupuse sequence has been completed, the “Groupuse execution in progress” bit in the Auxiliary 2 status word in the rxstatus log, see Page 172, should be used.

Syntax

groupuse startstop groupname [dst] [filename]

Message ID = 149

Field		Data		Value Used if	Bytes	Format	Units	Offset
				Not Specified
1	Header			-		-	-	0
2	Group Action, see Table 45 on			-	4	Enum	none	H
	Page 119
3	Group name			-	12	Char[]	none	H+4
4	Serial Port Identifier, see			THISPORT	4	Enum	none	H+16
	Appendix C, Logs, Table 67 on
	Page 150
5	Filename			NUL	12	Char[]	none	H+20
		Table 45: Group Action
		Binary Value	ASCII Value		Description

0

1

START	Start the specified group
STOP	Stop the specified group

DL-V3 User Manual Rev 3 119