JVC KD-SH909 manual Set the minute, Select OFF Finish the setting, Is turned off, press Disp D

Canceling the display demonstration

When shipped from the factory, display demonstration has been activated, and starts automatically when no operations are done and no sound comes in for about 3 minutes.

To cancel the display demonstration, follow

the procedure below.

1 Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display. (See page 31.)

2 Select “DEMO MODE” if not appears on the display.

Setting the clock

1 Press and hold SEL (select) for more than 2 seconds so that one of the PSM items appears on the display.

(See page 31.)

2 Set the hour.

1Select “CLOCK H (hour)” if not shown on the display.

2 Adjust the hour.

1 2

3 Set the minute.

1Select “CLOCK M (minute).”

2 Adjust the minute.

1 2

ENGLISH

3	Select “OFF.”
		4 Finish the setting.
4	Finish the setting.	To check the current clock time while the unit
		is turned off, press DISP (D).

The power turns on, the clock time is shown for 5 seconds, then the power turns off.

To activate the display demonstration again,

repeat the same procedure and select “ON” in

step 3.

Note:

If the unit has been reset (and the power is on), demonstration will start when no operation is done and no sound comes in for about 10 seconds.

9