Alpine CDM-7859R, CDM-7858R, CDM-7856R owner manual Installation, Removal

Installation

1

	Rubber Cap
	(Included)
Bracket	Hex Bolt
	(Included)

Dashboard

Mounting sleeve (Included)

CDM-7859R/CDM-7858R/ CDM-7856R

Remove the Detachable Front Panel (refer to page 4). Slide mounting sleeve from main unit (see Removal Procedure below). Slide the mounting sleeve into the dashboard.

2 Metal Mounting Strap

Screw

3 Slide the CDM-7859R/CDM-7858R/CDM-7856R into the dashboard. When the unit is in place, make sure the locking pins are fully seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the Detachable Front Panel.

Lock pin

Removal

1Remove the detachable front panel.

2Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see Fig. 3). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

3Pull the unit out, keeping it unlocked as you do so.

∗

Hex Nut (M5)

Bolt Stud

<JAPANESE CAR>

Front frame

CDM-7859R/CDM-7858R/ CDM-7856R

When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the CDM- 7859R/CDM-7858R/CDM-7856R and put the Rubber Cap on the hex bolt. If your vehicle does not have the Mounting Support, reinforce the head unit with the metal mounting strap (not supplied). Connect all the leads of the CDM- 7859R/CDM-7858R/CDM-7856R according to details described in the CONNECTIONS section.

NOTE

For the screw ∗ , provide a proper screw to the chassis installing location.

Screws (M5 ⋅ 8)

CDM-7859R/CDM-7858R/ (Included)

CDM-7856R

Mounting Bracket

19-EN