1ISO Antenna Convertor Plug
2Audio Interrupt In Lead (Pink/Black)
Connect this lead to the Audio Interface output of a cellular phone which provides ground shorting when a call is received.
If a device having the interrupt feature is connected, audio will be automatically muted whenever the interrupt signal is received from the device.
3Remote
Connect this lead to the remote
4Switched Power Lead (Ignition) (Red)
Connect this lead to an open terminal on the vehicle’s fuse box or another unused power source which provides (+) 12V only when the ignition is turned on or in the accessory position.
5Ground Lead (Black)
Connect this lead to a good chassis ground on the vehicle. Make sure the connection is made to bare metal and is securely fastened using the sheet metal screw provided.
6Power Antenna Lead (Blue)
Connect this lead to the +B terminal of your power antenna, if applicable.
NOTE
This lead should be used only for controlling the vehicle's power antenna. Do not use this lead to turn on an amplifier or a signal processor, etc.
"Remote Control Interface Connector
To remote control interface box.
#Rear/Subwoofer Output RCA Connectors
RED is right and WHITE is left.
$ DIN Connector
Connect this to the DIN connector on the CD changer.
%DIN Extension Cable (Included with CD changer)
NOTE
Older Alpine CD changer came with standard, straight type DIN connectors. In installations where an
&Power Supply Connector
( ISO Connector (Speaker Output)
) Left Rear (+) Speaker Output Lead (Green)
~Left Rear
Black)
+Left Front (+) Speaker Output Lead (White)
,Left Front
Black)
. Right Front (+) Speaker Output Lead (Grey) / Right Rear
Black)
: Right Rear (+) Speaker Output Lead (Violet) ; RCA Extension Cable (sold separately)
7Fuse Holder (15A)
8Battery Lead (Yellow)
Connect this lead to the positive (+) post of the vehicle’s battery.
9ISO Power Supply Connector
!Antenna Receptacle
Connect to the supplied ISO antenna convertor plug.
To prevent external noise from entering the audio system.
•Locate the unit and route the leads at least 10 cm away from the car harness.
•Keep the battery power leads as far away from other leads as possible.
•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.