Parking Brake Lead Connection
If necessary, use a pinch connector to connect the foot brake lead, parking brake lead, etc.
1 Vehicle Cable2
Pinch Connector
Pliers
Monitor Cable
Stopper
Foot Brake Lead / Parking Brake Lead Connection
FOOT BRAKE |
| Foot brake lamp |
|
|
| Foot brake switch | |
(Yellow/Black) |
| Foot brake lead | |
Pinch |
| ||
|
|
| |
PARKING BRAKE | Connector |
| Chassis |
| Parking brake lamp | Battery | |
| Pinch | ||
(Yellow/Blue) |
|
| |
| Connector | Parking brake lead | Parking brake switch |
|
|
|
Connection Diagram of SPST Switch (Sold Separately)
(If the ACC power supply is not available)
| FUSE (5A) |
SPST SW (Optional) | (Optional) |
IGNITION |
|
(Red) |
|
BATTERY |
|
(Yellow) | FUSE (20A) |
| |
| (Optional) |
Battery
•If your vehicle has no ACC power supply, add an SPST
•The diagram and the fuse amperage shown above are in the case when
•If the switched power (ignition) lead of the
Speaker Input Lead Connection |
| ||
1 Cut the car audio's speaker leads. | 2 Connect the leads together. | ||
|
|
| Connect the supplied pinch connector. |
|
|
|
|
To prevent external noise from entering the audio system.
•Locate the unit and route the leads at least 10 cm away from the car harness.
•Keep the battery power leads as far away from other leads as possible.
•Connect the ground lead securely to a bare metal spot (remove any paint, dirt or grease if necessary) of the car chassis.
•If you add an optional noise suppressor, connect it as far away from the unit as possible. Your Alpine dealer carries various noise suppressors, contact them for further information.
•Your Alpine dealer knows best about noise prevention measures so consult your dealer for further information.