Sharp SD-AT1000W operation manual Setting the clock

SD-AT1000W(LAG) TINSZA121AWZZ

Setting the clock				SD-AT1000W
				ENGLISH
By setting the unit to the correct time, you can use it not only as a clock but also for	3 Press the	or	button to adjust the
timer playback.
	hour and then press the ENTER but-
	ton.
	! Press the	or	button once to advance the time by 1 hour. Hold it down to
	advance continuously.
	! When the 12-hour display is selected, "AM" will change automatically to "PM".
	4 Press the	or	button to adjust the
	minutes and then press the ENTER
	button.
	! Press the	or	button once to advance the time by 1 minute. Hold it down	Use
	to advance continuously.
	! The hour will not advance even if minutes advance from "59" to "00".
	! The clock starts from "0" second (seconds are not displayed).			Preparationfor
	! The time disappears after approx. 5 seconds.				theSetting- clock -
	To confirm the time display:
	Press the CLOCK button.
You can set the clock even when the unit is in the stand-by mode.	The time display will appear for about 5 seconds.
In this example, the clock is set for the 24-hour (0:00) display.	Note:
1 Press the CLOCK button and within 5 seconds, press the ENTER	The "ADJUST" or time will flash at the push of the CLOCK button when the AC power
	supply is restored after a power failure or unplugging the unit.
button.	Readjust the clock as follows.
	To readjust the clock:
	Perform "Setting the clock" from step 1. If the "ADJUST" is not flashing in step 1, step
	2 (for selecting the 24-hour or 12-hour display) will be skipped.
2 Press the or button to select the 24-hour or 12-hour display and	To change the 24-hour or 12-hour display:
then press the ENTER button.	1 Clear all the programmed contents. [Refer to "Clearing all the memory (reset)" on
	page 31 for details.]
	2 Perform "Setting the clock" from the beginning.

"0:00" The 24-hour display will appear. (0:00 - 23:59)

"12:00 AM" The 12-hour display will appear. (AM 12:00 - PM 11:59)

"AM 0:00" The 12-hour display will appear. (AM 0:00 - PM 11:59)

Note that this can only be set when the unit is first installed or it has been reset (see page 31).

E-18

4

1

2

3

4

5

6

7

8

04/7/9 SD-AT1000W_LAG_E3.fm TINSZA121AWZZ