Siemens SL45 manual Setup, Network

	Setup		61
0HQX Î Setup Î Security Î		Network
	then select function:
PIN Control		0HQX Î Setup Î Network Î
		then select a function:
The PIN is usually requested each		Connection	C
time the phone is switched on. You
can deactivate this control but you		This function is only displayed if it is
risk unauthorised use of the phone.		supported by the Service Provider.
Some Service Providers do not per-		Two independent phone numbers
mit this function.
		must be registered on the phone.
Prevent new SIM		Select

(Phonecode)

The operation of your phone with another SIM card is prevented.

Codes

PIN 1

You can change the PIN to any

4 - 8 digit number (i.e . a number you may find easier to remember).

￿Enter old PIN.

2. Press.

￿/ 2. Enter new PIN.

￿/ 2. Repeat new PIN.

PIN 2

You can change the PIN 2 to any 4-8 digit number (display only when PIN2 is available).

Proceed as with PIN 1.

Phonecode

The default is 0000. You can also change the phone code to any 4 - 8 digit number. Proceed as with PIN 1.

Select the currently used phone number.

If you change frequently, it is more convenient to make the selection using the soft key (see p. 65).

￿Display the active phone number.

Special settings can be made for each pho- ne number (e.g. melody, call diversion etc). Switch to the required phone number first.

To switch the phone number/line: (in standby mode)

￿Press, then:

/LQH Press.

Lock

(Phonecode)

You may limit usage to one phone number.