Weslo WLSY71500 owner manual Important If the cables are

Page 12

27.Wet the ends of the Lat Bar and insides of the two remaining Handgrips (48) with soapy water. Slide the Handgrips onto the ends of the Lat Bar.

27

48

85

48

28.Remove the decals from the Decal Sheet (not shown), and apply them to the weight system in the locations shown in the drawing below.

28

HIGH PULLEY

BENCH PRESS/

BUTTERFLY COMBINATION

LEG EXTENSION

LOW PULLEY

29.Make sure that all parts are properly tightened. The use of all remaining parts will be explained in ADJUST- MENT, beginning on page 13 of this owner's manual. Before using the weight system, pull each cable a few times to make sure that the cables move smoothly over the pulleys. If one of the cables does not move

smoothly, locate and correct the problem before using the weight system.

IMPORTANT: If the cables are

not properly routed, they may be damaged when heavy weight is used. See the CABLE DIAGRAM on

 

page 18 of this owner’s manual.

 

12

Image 12
Contents QUESTIONS? Model No. WLSY71500 Serial NoCustomer HOT Line Patent Pending Table of Contents Important PrecautionsBefore YOU Begin BodyAssembly Assembly requires two people.Due to the sizeFollowing Tools not Included are Required for Assembly Nuts yetNuts 3.Do not tighten the Nylon Lock Nuts yet Do not tighten Nylon Lock Nuts yetDo not tighten Nylon Lock Nut yet Lubricate One of the Arms 46. Attach the Handle with a 5/16 Bracket must be able to swivel freely Swivel Bracket must be able to swivel freelyImportant As you assemble the Long Cable Page Important The Short and Long Cables ManualPage Important If the cables are Adjustment Changing the Weight SettingTion will vary from the weight setting Switching the Arms to the Press Mode or Butterfly ModeAttaching the LEG Lever to the LOW Pulley Station Attaching the LAT BAR or Nylon Strap to High Pulley StationAttaching the LAT BAR or Nylon Strap to LOW Pulley Station TROUBLE-SHOOTING and Maintenance Tightening the CablesPart LIST-Model No. WLSY71500 Exploded DRAWING-Model No. WLSY71500 Cable Diagram Page Ordering Replacement Parts Limited WarrantyWeslo INC., 1500 S W., LOGAN, UT Remove this Part Identification Sheet from the Manual Inner Cap Round Cap 4 Inner Cap Cover Cap 2 Inner Cap