Weslo WLSY71500 owner manual Attaching the LEG Lever to the LOW Pulley Station

Page 14

ATTACHING THE LEG LEVER TO THE LOW

PULLEY STATION

To use the Leg Lever (29), the seat must be attached to the front upright (see ATTACHING AND REMOV-

ING THE SEAT on page 13). Attach the Chain (84) between the Short Cable (23) and the 5/16” x 2” Eyebolt (35) on the Leg Lever with two Cable Clips (83).

ATTACHING THE LAT BAR OR NYLON STRAP TO

THE HIGH PULLEY STATION

Attach the Lat Bar (85) to the Long Cable (66) with a Cable Clip (83). For some exercises, the Chain (84) should be attached between the Lat Bar and the Long

Cable with two Cable Clips. Adjust the length of the

Chain between the Lat Bar and the Long Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Nylon Strap (39) can be attached in the same manner.

ATTACHING THE LAT BAR OR NYLON STRAP TO

THE LOW PULLEY STATION

Attach the Lat Bar (85) to the Short Cable (23) with a Cable Clip (83). For some exercises, the Chain (84) should be attached between the Lat Bar and the Short

Cable with two Cable Clips. Adjust the length of the

Chain between the Lat Bar and the Short Cable so the Lat Bar is in the correct starting position for the exercise to be performed.

The Nylon Strap (39) can be attached in the same manner.

 

83

29

 

 

23

 

 

84

 

35

66

83

 

 

85

 

 

84

 

 

 

 

39

23

 

39

83

84

 

 

 

85

 

 

83

14

Image 14
Contents Customer HOT Line Patent Pending QUESTIONS?Model No. WLSY71500 Serial No Table of Contents Important PrecautionsBefore YOU Begin BodyFollowing Tools not Included are Required for Assembly AssemblyAssembly requires two people.Due to the size Nuts yetDo not tighten Nylon Lock Nut yet Nuts 3.Do not tighten the Nylon Lock Nuts yetDo not tighten Nylon Lock Nuts yet Lubricate One of the Arms 46. Attach the Handle with a 5/16 Important As you assemble the Long Cable Bracket must be able to swivel freelySwivel Bracket must be able to swivel freely Page Important The Short and Long Cables ManualPage Important If the cables are Tion will vary from the weight setting AdjustmentChanging the Weight Setting Switching the Arms to the Press Mode or Butterfly ModeAttaching the LAT BAR or Nylon Strap to LOW Pulley Station Attaching the LEG Lever to the LOW Pulley StationAttaching the LAT BAR or Nylon Strap to High Pulley Station TROUBLE-SHOOTING and Maintenance Tightening the CablesPart LIST-Model No. WLSY71500 Exploded DRAWING-Model No. WLSY71500 Cable Diagram Page Weslo INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty Remove this Part Identification Sheet from the Manual Inner Cap Round Cap 4 Inner Cap Cover Cap 2 Inner Cap