Weslo WLSY71500 owner manual Lubricate

Page 6

6.Press the Weight Tube Bumper (79) into the indi- cated end of the Weight Tube (80).

Insert the Weight Tube (80) into the stack of Weights (25). Slide the eighth Weight (25) onto the upper end of the Weight Tube. The Weight

Tube must be turned so the welded pin is in the pin groove in the Weight.

Locate the lower ends of the Weight Guides

(72)—there are holes near the upper ends. Insert the lower ends of the Weight Guides into the eight Weights (25).

7.Attach the upper ends of the Weight Guides (72) to the Top Frame (67) with the 5/16” x 6” Bolt (74), the two Weight Guide Spacers (73) and a 5/16” Nylon Lock Nut (3).

8.Press two 1 3/4” Inner Caps (44) and two 1” Round Inner Caps (49) into the Arm Frame (52).

Apply lubricant to the upper axle on the Arm Frame (52). Hold the axle between the two Arm Frame Bushings (68). Set the Arm Frame Bushings and the Arm Frame on the plate welded to the top of the Top Frame (67). The Arm Frame must be turned so the bracket is facing away from the Front Upright (42). Place the Arm Frame Bracket (69) over the Arm Frame Bushings. Attach the Arm Frame Bracket to the Top Frame

with four 1/4” x 3/4” Screws (18) and 1/4” Nylon Lock Nuts (7).

6

 

 

 

 

Upper Ends of

 

 

Weight Guides

 

 

have Holes

 

 

72

 

25

 

 

 

Pin

 

 

Groove

 

80

Welded

 

 

 

 

Tube

 

 

79

 

 

25

7

 

 

 

73

 

 

72

3

 

 

67

 

74

 

 

72

 

8

7

52—Lubricate

 

 

 

 

69

49

 

68

44

 

67

 

 

 

 

49

 

 

44

 

18

Bracket

 

 

 

42

 

6

Image 6
Contents QUESTIONS? Model No. WLSY71500 Serial NoCustomer HOT Line Patent Pending Table of Contents Important PrecautionsBefore YOU Begin BodyFollowing Tools not Included are Required for Assembly AssemblyAssembly requires two people.Due to the size Nuts yetNuts 3.Do not tighten the Nylon Lock Nuts yet Do not tighten Nylon Lock Nuts yetDo not tighten Nylon Lock Nut yet Lubricate One of the Arms 46. Attach the Handle with a 5/16 Bracket must be able to swivel freely Swivel Bracket must be able to swivel freelyImportant As you assemble the Long Cable Page Important The Short and Long Cables ManualPage Important If the cables are Tion will vary from the weight setting AdjustmentChanging the Weight Setting Switching the Arms to the Press Mode or Butterfly ModeAttaching the LEG Lever to the LOW Pulley Station Attaching the LAT BAR or Nylon Strap to High Pulley StationAttaching the LAT BAR or Nylon Strap to LOW Pulley Station TROUBLE-SHOOTING and Maintenance Tightening the CablesPart LIST-Model No. WLSY71500 Exploded DRAWING-Model No. WLSY71500 Cable Diagram Page Ordering Replacement Parts Limited WarrantyWeslo INC., 1500 S W., LOGAN, UT Remove this Part Identification Sheet from the Manual Inner Cap Round Cap 4 Inner Cap Cover Cap 2 Inner Cap