Sembly. Make sure that no wires are pinched

7. Set the console assembly face down on a soft	7
surface to avoid scratching it. Hold a Handrail	7
surface to avoid scratching it. Hold a Handrail
(18) near the console assembly.
Next, insert the console wire into the hole in the	Console
bottom of the Handrail (18) and out of the indi-	Wire	22
cated square hole. If necessary, grip the con-	18	22
cated square hole. If necessary, grip the con-		21	2
nector with needlenose pliers only in the area		21
nector with needlenose pliers only in the area
indicated by the arrow (see the inset drawing.)
Then, attach the ground wire to the Handrail with	Square
a Silver Ground Screw (11).	Square
a Silver Ground Screw (11).	Hole		Ground
	Hole		Ground
Next, set the Handrail (18) on the console as-			Wire
sembly. Make sure that no wires are pinched.	Console		11
Finger tighten a Console Bolt (22) with a 1/4"	Assembly
Star Washer (21) into the Handrail, and then
start two 3/4" Screws (2) into the Handrail.
Tighten the Console Bolt and then the two
Screws; do not overtighten the Screws.
Attach the other Handrail (not shown) to the con-
sole assembly in the same way. Note: There are
no wires on the other side.
8. Insert the Upright Wire (28) through a Handrail	8
Spacer (88) as shown. Attach the Handrail	8
Spacer (88) as shown. Attach the Handrail		88
Spacer to the Right Upright (36) with a 3/4"		88
Screw (2).
Attach the other Handrail Spacer (not shown) to	2
Attach the other Handrail Spacer (not shown) to
the Left Upright (not shown) as described above.	28
Note: There is not a wire on the left side.			36
			36
9. While another person holds the Console Base	9
(26) near the right Handrail (18). Connect the	9
(26) near the right Handrail (18). Connect the
console wire to the Upright Wire (28) as shown
in the inset drawing. Important: If the connec-
tors are oriented correctly, they will slide to-	18
gether easily and snap into place. If the con-	18
nectors are not oriented correctly, the con-			26
sole may be damaged when the power is			26
turned on. Insert the connectors into the Right	36	Console Wire
Upright (36).		Console Wire
Upright (36).
Attach the Console Base (26) to the Right		28
Attach the Console Base (26) to the Right
Upright (36) and the Left Upright (not shown)	19
with four Handrail Bolts (20) and four Handrail
Star Washers (19) (only one side is shown).	20		28
Start all four Handrail Bolts before tightening	20		28
any of them.	19
	19
	20
	9

sembly. Make sure that no wires are pinched.

Start all four Handrail Bolts before tightening

any of them.