Bushnell 11-8313 Camera Operation Instructions, Button Descriptions, LCD Display, Operation Guide

Congratulations on your purchase of a Bushnell ImageView binocular. Before using the product, please read the instructions contained in this manual and take time to familiarize yourelf with the different parts and features of the product.

CAMERA OPERATION INSTRUCTIONS
BUTTON DESCRIPTIONS
	Mode	Snap
The MODE button has three functions:

1.Power on: Press and hold button until the camera turns on. When the camera is connected to your PC via the USB cable provided, the camera will power on automatically.

2.Power off: While the camera is on, press and hold the button until camera turns off. If camera has not been used or if a button has not been pressed for over 2 minutes, the camera will automatically power off to save battery life. If the camera is connected via the USB cable, it will not power off except when PC is turned off.

3.Mode change: Press this button rapidly to change modes.

The SNAP button has two functions:

1.Take a picture: Press this button to take a picture when the camera is on. (But not in the PC mode or mode change.

2.Select: In “Mode Change”, press this button to confirm the function.

1

11-8313 IMAGEVIEW MANUAL 4-5

LCD DISPLAY

1. High Resolution Mode = 1280x1024 Pixels

2. Low Resolution Mode = 1024x768 Pixels

3. Select the timer to take a delayed picture. This gives you approximately a 10-second delay.

4. This mode allows you to take short movie clips, saved as “.avi” files.

5. Selects different modes.

6.Deletes all the pictures in the memory.

7.Deletes the last picture taken.

8.USB mark appears when USB cord is connected between the camera and the PC.

9. Battery mark keeps track of the battery life left.

10. a. Picture Number-- This area will show the number of pictures in the memory.

b. SET-- select Hq (high quality)/Lq (low quality) mode, STO (Mass Storage)/ PCC (PC Cam) mode, 50Hz/60Hz frequency

c.FUL--When the memory is full, the display will show “FUL” and alarm will sound.

OPERATION GUIDE

1.The camera is powered by two AAA batteries (included) or USB power (included).

2.Insert the battery into battery compartment.

3.Press and hold the MODE button until camera turns on.

4.Press SNAP to take a picture, or press the MODE button quickly to change mode settings as described above. The camera is set at infinity and will not be focused on an object closer than 49 feet.

5.The mode setting operation is a cycle loop, so press the MODE button to switch to another mode. 2

3/11/04, 2:59 PM