Cannon 5 ST, 10 STX TS owner manual Removable Spool Cover, Removing or replacing the spool

Page 11

FIGURE 13

FIGURE 14

FIGURE 15

FIGURE 16

REMOVABLE SPOOL COVER

Installation

Your new downrigger comes with a removable

spool cover. By removing this cover, you are able to

 

gain easy access to your spooled cable and easy

 

spool removal. This feature allows you to easily ac-

 

cess tangled line, get it repaired and get you back into

 

action quickly.

 

This feature also allows you to have multiple reels

 

for different types of line. By purchasing additional

 

reels, you can wind each with a different type of cable

 

(i.e. Uncoated cable, Coated Cable, Mono, etc.). This

 

allows you to switch out desired cables quickly and

 

easily.

 

NOTE: Remove all tension from the line before

 

removing or replacing the spool.

 

Follow the below steps to remove the side cover:

 

1)Loosen and remove the clutch knob. Turn the clutch knob clockwise until it is free of the motor shaft. (Figures 13 & 14)

2)Loosen the two 1/4-20 Phillips head screws on op- posite sides on the cover. (Figure 15)

NOTE: Screws are captured in the cover and will not come out completely.

3)Remove the cover and you now have complete access to the spool. (Figures 16 & 17)

4)Reassemble by reversing the above steps.

NOTE: Take care when removing the spool over open water so that the clutch pad or clutch disk doesn’t get pulled off as well. (Figure 17)

WARNING: Do not touch the cable reel while the downrigger is in use.

11

FIGURE 17

www.cannondownriggers.com

Image 11
Contents Magnum 5 ST Magnum 10 STX Magnum 10 STX TS Table of Contents Introduction Overview Safety and CautionsWarranty and Registration Cannon Limited Warranty Cable ReelBoom Decks thicker than 7/16 Installing the Base on Your Boat Decks up to 7/16 thickDownrigger Mounting on Boats Low-Profile Swivel Base Decks thinner than 1/4Installing the Boom and Ball Hook Telescopic Boom only Fixed Length Boom Magnum 5 models only Boom END PulleyTelescopic Boom Removing or replacing the spool Removable Spool CoverAttaching the ROD Holders Replacing the Clutch PADTerminating the Downrigger Cable Using the Included Power Loss Manual Crank Handle Your Boats Electrical Condition Electrical Specifications & Wiring InstructionsConnecting to the Battery Red Black Connect Multiple Fuse / Breaker SpecificationsManual Descent Fast or Slow Powered Descent One speed fits allRaising the Weight Cable Terminator Weight Insulator Adjusting the Depth MeterShown on meter due to trolling speed and weight Weight insulatorsPositive Ion Control System Fishing With Your DownriggerMaintaining Your Downrigger Using Positive Ion ControlHow the Positive Ion Control System Works MPH Weight ft10-Lb. Weight at 2, 4, and 6 MPH BlowbackLocate fish on a vertical plane . Place lures in ar Ten Good Trolling TipsConsider different sizes , shapes, and colors Vary trolling patterns and lead lengths .Solution TroubleshootingProblem Magnum 5 ST Magnum 5 ST Magnum 5 ST /E List Parts Magnum 10 STX 84 2200148 ASY Snap & Insulator Magnum 10 STX /E 88 3391732 WASHER, Sealing 89 3394602 WASHER, FLAT, #8, SS Magnum 10 STX TS 32 9100070 CON Leader Sleeve Magnum 10 STX TS /E 36 3394605 O-RING, Knob Magnum Series Wiring Diagram This page Intentionally Left Blank Environmental Compliance Statement