Wiring Your Downrigger
Your Boat's Electrical Condition
It is important to make sure that your boat is properly set up before installing your Magnum with Positive Ion Control (PIC). Whenever a boat is in water, various submerged parts interact to create weak electrical currents. These weak electrical currents must be controlled to extend the life of the boat's metal parts and ensure a good fish catching environment.
Check the zinc sacrificial anodes on your boat and on the outboard/outdrive. If they are more than 50% dis- solved they should be replaced. Any coating of slime or growth should be cleaned off. All metal parts including the hull (if metal) must be interconnected by a grounding wire. This includes motor shafts, outdrives, and through hull fittings. If your boat and zinc anodes are set up correctly, the voltage on the stainless steel downrigger wire should be positive when in contact with the water.
With your boat in the water and the downrigger cable deployed in the water, measure the dc voltage from the cable to a grounded metal surface of the boat touching the water. It should be
•The use of Cannon vinyl coated lead weights is recommended.
•Use the trolling weight insulators supplied with your downrigger. This insulates your weight from the positive charge on the cable. This will also ensure that the trolling weight will stop at water level when retrieved.
•The cable on your downrigger should be replaced every 2 years. Etching of the cable can weaken it physically and electrically.
•In saltwater, make sure the sacrificial zinc anodes are replaced when half dissolved. This ensures that the boat will run with a neutral or slightly positive charge. Clean zincs on a regular basis with a
•Always make sure the boat is properly grounded to the water. This will help ensure proper PIC voltage on the cable and that the Short Stop will function properly.
NOTE: To ensure proper operation of your Magnum, ground the battery to your boat’s electrical system’s ground. Malfunctions with the PIC, communication between units, or loss of operation result from faulty grounding. Always check to see if your boat is properly grounded first.
Electrical Specifications & Wiring Instructions
The Magnum series is rated at 30 amps (full load), 12 volts DC and is protected by a 25 amp manual reset cir- cuit breaker (located under motor housing). Be sure to measure the battery voltage of your boat.
WARNING! - DO NOT RUN THIS DOWNRIGGER ON A 24 VOLT BATTERY SYSTEM. THIS WILL DAMAGE THE UNIT AND VOID YOUR WARRANTY.
Connecting to the Battery:
It is strongly recommended that a fuse or manual reset circuit breaker be installed at the battery on the positive lead of the power cable or that you connect the downrigger to a battery selector switch. (See Fuse and Wire Speci- fications) Connect the positive lead (RED) to the (+) post on your battery and the negative lead (BLACK) to the
NOTE: It is strongly recommended to power your Magnum with a
Tip: Control degradation of the power cables and limit corrosion by using
Installation
15
www.cannondownriggers.com