Cannon 10 STX TS, 5 ST owner manual Fishing With Your Downrigger, Positive Ion Control System

Page 19

Fishing With Your Downrigger

Release some line from your rod and reel so that the lure is anywhere from 5 to 100 feet behind the boat. This is called drop back. Attach the fishing line firmly into the line release. Place the fishing rod in the rod holder and reel up the slack so that your rod has a slight bend in it. When a fish strikes the lure, the line will sepa- rate from the release. Then you will be free to fight the fish and bring it in on your rod and reel.

WARNING—DO NOT TOUCH THE CABLE REEL WHILE THE DOWNRIGGER IS IN USE!

The Positive Ion Control System

Fishing

 

Your boat has an electrical charge around the hull in

Theory

water. If a boat is properly grounded and has a proper

 

zinc anode, that charge should be slightly positive when

 

measured from ground to the downrigger cable. Positive

 

Ion Control (PIC) is the use of electricity to control that

 

charge and its fluctuation so that it is always maintained

 

at a specified set voltage.

 

The practice of setting up and maintaining a slight

 

positive charge on fishing gear has been used by com-

 

mercial fishermen for many years. This practice has en-

 

abled some fisherman to increase yield when used

 

along with other good fishing and boating practices.

 

Cannon's electric downriggers offer fishermen a big

 

advantage in being able to stabilize and control the posi-

 

tive charge around their boat. Because of the composite

 

construction of the frame, Cannon downriggers are insu-

 

lated from your boat's hull charge.

 

When the stainless steel downrigger cable is low-

 

ered into the water, the natural ionization between the

 

cable and the boat creates a positive charge of 0.7 to

 

0.9volts in saltwater and 0.3 to 0.6 volts in fresh water. This natural voltage is dependent upon salinity and min- eral content of the water. Your actual voltage may vary.

19

www.cannondownriggers.com

Image 19
Contents Magnum 5 ST Magnum 10 STX Magnum 10 STX TS Table of Contents Warranty and Registration Safety and CautionsIntroduction Overview Cannon Limited Warranty Boom ReelCable Downrigger Mounting on Boats Installing the Base on Your Boat Decks up to 7/16 thickDecks thicker than 7/16 Low-Profile Swivel Base Decks thinner than 1/4Installing the Boom and Ball Hook Telescopic Boom only Telescopic Boom Boom END PulleyFixed Length Boom Magnum 5 models only Removing or replacing the spool Removable Spool CoverAttaching the ROD Holders Replacing the Clutch PADTerminating the Downrigger Cable Using the Included Power Loss Manual Crank Handle Connecting to the Battery Electrical Specifications & Wiring InstructionsYour Boats Electrical Condition Red Black Connect Multiple Fuse / Breaker SpecificationsRaising the Weight Powered Descent One speed fits allManual Descent Fast or Slow Cable Terminator Weight Insulator Adjusting the Depth MeterShown on meter due to trolling speed and weight Weight insulatorsPositive Ion Control System Fishing With Your DownriggerHow the Positive Ion Control System Works Using Positive Ion ControlMaintaining Your Downrigger MPH Weight ft10-Lb. Weight at 2, 4, and 6 MPH BlowbackLocate fish on a vertical plane . Place lures in ar Ten Good Trolling TipsConsider different sizes , shapes, and colors Vary trolling patterns and lead lengths .Problem TroubleshootingSolution Magnum 5 ST Magnum 5 ST Magnum 5 ST /E List Parts Magnum 10 STX 84 2200148 ASY Snap & Insulator Magnum 10 STX /E 88 3391732 WASHER, Sealing 89 3394602 WASHER, FLAT, #8, SS Magnum 10 STX TS 32 9100070 CON Leader Sleeve Magnum 10 STX TS /E 36 3394605 O-RING, Knob Magnum Series Wiring Diagram This page Intentionally Left Blank Environmental Compliance Statement