Installation | REPLACING THE CLUTCH PAD |
removing the spool. Once the spool is removed, you | |
| To replace the clutch pad, follow the steps for |
| have access to the clutch pad. (Figure 18) Simply pull it |
| off the shaft and replace. Reassemble the spool and |
| cover in the reverse order. |
ATTACHING THE ROD HOLDER(S)
The locking rod holder(s) incorporate a locking tooth design which can be easily adjusted every 15° with the soft grip knob. The symmetrical design will al- low mounting of the rod holder on either side of the downrigger or two rod holders at the same time. The unique two piece design allows independent adjustment of the rod holder and the rod holder arm in two axes. (Figure 19)
Caution: This rod holder is intended for use of up to 30 lb. test line only and is not recommended for use with any tackle IGFA (International Game Fish Association) rated higher than 30 lb. A safety strap (not included) is recommended for all applications.
NOTE: The rod holder assembly is not covered un- der warranty when used with tackle above 30 lbs. Equipment placed in the rod holders and the loss thereof is the responsibility of the user and is in no way warranted by Johnson Outdoors, Inc. Mounting must be in accordance with the above instructions and pictures to comply with the product warranty.
To install the rod holder(s):
1)Fasten rod holder to rod holder elbow using supplied spring and knob.
2 ) Attach the rod holder to the downrigger on either side using the supplied spring and knob. (Figure 20)
3)Repeat the above steps for the other side if (2) rod holders are to be mounted.
The rod holders can be adjusted by loosening either knob until the locking teeth are free from each other. Rotate the rod holder or arm to the desired position and
12
www.cannondownriggers.com
FIGURE 18
FIGURE 19
FIGURE 20
FIGURE 21