Cannon 5 ST, 10 STX TS owner manual Telescopic Boom only

Page 9

FIGURE 5

FIGURE 6

FIGURE 7

FIGURE 8

6) Insert the 1/4-20 nylon locknut into the hex pocket on

Installation

 

the nose of the frame (motor side of frame). (Figure 5)

 

7) Insert 1/4-20 x 2” bolt into reel side of frame nose.

 

With a Phillips head screw driver, thread bolt into the

 

nylon locknut from step 6. Tighten bolt until the end of

 

the bolt is flush with the top of the nut. (Figure 6)

 

8) Slide ball hook collar to your preferred location. Hand

 

tighten the ball hook into boom tube. Tighten enough so

 

that there is no movement on the boom. (Figure 7)

 

Important: Do not overtighten ball hook or perma- nent deformation of the boom is possible.

9)Once ball hook is secure, with a 7/16” wrench, tighten the 1/4-20 nut until secure with ball hook collar.

(Figure 8)

**TELESCOPIC BOOM ONLY**

To adjust the boom length (with the boom extending away from you) rotate the clamps (See item # 8 on page

5)approximately ¼ turn counter-clockwise to unlock and slide the boom section to the desired position. Once in place, lock the clamps by rotating clockwise until tight.

9

www.cannondownriggers.com

Image 9
Contents Magnum 5 ST Magnum 10 STX Magnum 10 STX TS Table of Contents Safety and Cautions Warranty and RegistrationIntroduction Overview Cannon Limited Warranty Reel BoomCable Installing the Base on Your Boat Decks up to 7/16 thick Downrigger Mounting on BoatsDecks thicker than 7/16 Low-Profile Swivel Base Decks thinner than 1/4Installing the Boom and Ball Hook Telescopic Boom only Boom END Pulley Telescopic BoomFixed Length Boom Magnum 5 models only Removing or replacing the spool Removable Spool CoverAttaching the ROD Holders Replacing the Clutch PADTerminating the Downrigger Cable Using the Included Power Loss Manual Crank Handle Electrical Specifications & Wiring Instructions Connecting to the BatteryYour Boats Electrical Condition Red Black Connect Multiple Fuse / Breaker SpecificationsPowered Descent One speed fits all Raising the WeightManual Descent Fast or Slow Shown on meter due to trolling speed and weight Adjusting the Depth MeterWeight insulators Cable Terminator Weight InsulatorPositive Ion Control System Fishing With Your DownriggerUsing Positive Ion Control How the Positive Ion Control System WorksMaintaining Your Downrigger 10-Lb. Weight at 2, 4, and 6 MPH Weight ftBlowback MPHConsider different sizes , shapes, and colors Ten Good Trolling TipsVary trolling patterns and lead lengths . Locate fish on a vertical plane . Place lures in arTroubleshooting ProblemSolution Magnum 5 ST Magnum 5 ST Magnum 5 ST /E List Parts Magnum 10 STX 84 2200148 ASY Snap & Insulator Magnum 10 STX /E 88 3391732 WASHER, Sealing 89 3394602 WASHER, FLAT, #8, SS Magnum 10 STX TS 32 9100070 CON Leader Sleeve Magnum 10 STX TS /E 36 3394605 O-RING, Knob Magnum Series Wiring Diagram This page Intentionally Left Blank Environmental Compliance Statement