7.Set the console assembly on the Left and Right Handrails (101, 102) and the Uprights (43). Be careful not to pinch any wires.
Tighten two 1/4" x 1/2" Patch Bolts (28) with two 1/4" Star Washers (116) into the Handrails (101, 102) and the console assembly. Do not fully tighten the Patch Bolts yet.
Attach the two Console Clamps (104) to the console assembly with four #8 x 1" Screws (115). Start all four Screws, and then tighten all of them. Be careful not to overtighten the Screws.
Tighten the two 1/4" x 1/2" Patch Bolts (28).
8.Orient the Latch Housing (89) so that the large hole is on the side shown. Attach the Latch Housing to the left Upright (43) with two #8 x 3/4" Screws (12). Do not overtighten the
Screws.
Locate the Latch Assembly (88). Remove the knob from the pin; make sure that the collar and the spring are on the pin. Then, insert the pin into the Latch Housing (89), and tighten the knob back onto the pin.
7 |
| Console |
|
|
|
|
| Assembly |
|
|
|
|
| 43 |
|
|
|
| 115 | 104 | 104 | 115 | 101 |
| 116 |
|
| 116 | |
|
|
|
| ||
|
| 28 |
|
| 28 |
|
| 102 |
|
|
|
8 |
|
|
|
|
|
| Knob 89 | 43 |
| 12 | Spring |
| Collar | |
88 | Large | |
Hole | Pin |
10