HOW to USE the Maintenance Mode

The console features a maintenance mode that allows you to calibrate the incline and speed of the treadmill, restore factory defaults, calibrate the screen, update the console firmware, and view technical information.

1.Select the settings mode. See step 1 on page 21.

2.Select the maintenance mode. Press the Maintenance button in the lower right corner of the screen to

enter the maintenance mode.

3.Calibrate the incline system of the treadmill. Press the Calibrate Incline button. The treadmill will automatically rise to the maximum incline level, lower to the minimum incline level and then return to the starting position. This will recalibrate the in- cline system. Press the Begin button to calibrate the incline or the Cancel button to return to the maintenance mode. When the incline system is calibrated, press the Back button.

IMPORTANT: Keep pets, feet, and other objects away from the treadmill while the incline is cali- brating. In an emergency, pull the key from the console to stop the incline calibration.

4.Restore factory defaults.

If necessary, press the Restore Defaults button to reset the firmware to the original factory firmware. This will erase all firmware updates that you have downloaded. Press the Begin button to restore the default firmware or the Cancel button to return to the maintenance mode.

When the restoration is complete, the words PLEASE CYCLE POWER will appear in the grey box. Switch the reset/off circuit breaker to the off position. Wait for several seconds, and then switch the circuit breaker to the reset position. It may take a minute for the console to be ready for use.

5.Calibrate the screen.

If the screen is not properly calibrated, it will be dif- ficult to press the buttons on the screen. To cali- brate the screen, press the Calibrate Screen button and then press the Begin button. Press the Cancel button to return to the maintenance mode.

Using a pencil eraser or other small object, press the center of the small target on the screen. Then, press the next two targets.

6.Calibrate the speed of the treadmill. Calibrate the speed of the treadmill only if in- structed to do so by an authorized service repre- sentative.

Note: The Calibrate Speed button may not be en- abled on your treadmill.

7.Update the console firmware.

For the best results, regularly check for firmware updates.

Press the Firmware Update button. Press the Begin button to check for updates or the Cancel button to return to the maintenance mode.

A status bar will appear in the grey box on your screen. When the update is complete, the words PLEASE CYCLE POWER will appear in the grey box. Switch the reset/off circuit breaker to the off position. Wait for several seconds, and then switch the circuit breaker to the reset position. It may take a minute for the console to be ready for use.

8.View technical information.

Press the Technical Info button to view the total number of hours that the treadmill has been used and the total number of miles that the walking belt has moved. When you are done viewing the infor- mation, press the Finish button.

9.Exit the maintenance mode.

To exit the maintenance mode, press the Back but- ton repeatedly.