Locate the Reed Switch (71) and the Magnet (50) on |
|
|
|
the left side of the Pulley (53). Turn the Pulley until the |
| 1/8 in. |
|
Magnet is aligned with the Reed Switch. Make sure |
| 53 | |
that the gap between the Magnet and the Reed |
| 9 | |
Switch is about 1/8 in. (3 mm). If necessary, loosen |
| 71 | 50 |
the #8 x 3/4" Washer Head Tek Screw (9), move the |
| ||
Reed Switch slightly, and then retighten the Screw. |
| Top |
|
Reattach the Motor Hood (not shown) and run the |
|
| |
treadmill for a few minutes to check for a correct |
| View |
|
speed reading. |
|
|
|
PROBLEM: The incline of the treadmill does not change correctly |
|
|
|
SOLUTION: a. Recalibrate the incline system (see step 3 on page 23). |
|
|
|
PROBLEM: The iFit Live mode is not functioning correctly |
|
|
|
SOLUTION: a. If the iFit Live mode is not functioning correctly, make sure that the treadmill has the most current | |||
firmware available (see step 7 on page 23). |
|
|
|
PROBLEM: The walking belt slows when walked on |
|
|
|
SOLUTION: a. Use only a | |||
b. If the walking belt is overtightened, treadmill perfor- | b |
|
|
mance may decrease and the walking belt may be- |
| ||
come damaged. Remove the key and UNPLUG THE |
|
| |
POWER CORD. Using the hex key, turn both idler |
|
|
|
roller bolts counterclockwise, 1/4 of a turn. When the |
|
|
|
walking belt is properly tightened, you should be able |
|
|
|
to lift each edge of the walking belt 3 to 4 in. (8 to 10 |
|
|
|
cm) off the walking platform. Be careful to keep the |
|
|
|
walking belt centered. Then, plug in the power cord, |
| Idler Roller Bolts |
|
insert the key, and run the treadmill for a few minutes. |
|
| |
Repeat until the walking belt is properly tightened. |
|
|
|
c. If the walking belt still slows when walked on, see the front cover of this manual. |
| ||
27