NordicTrack NTL07007.1 user manual

Page 27

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, first remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left rear roller bolt clockwise 1/2 of a turn; if the walking belt has shifted to the right, turn the bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is centered.

b. If the walking belt slips when walked on, first re- move the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts clock- wise, 1/4 of a turn. When the walking belt is cor- rectly tightened, you should be able to lift each side of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is prop- erly tightened.

a

b

27

Image 27

Contents QUESTIONS? Model No. NTL07007.1 Serial NoCall TOLL-FREE Table of Contents Important Precautions Page Before YOU Begin Hardware may be included AssemblyNut the Wheel must turn freely. Discard Make sure that the power cord is unpluggedSee the inset drawing. Tie the wire tie Do not fully fold the Frame yetFully tighten the Bolts yet Be careful not to pinch the Upright WireSee assembly steps 4 and 6. Firmly tighten the 3/8 x 4 Bolts Pull on the sleeve to make sure that it is locked into place Make sure that no wires are pinched Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Console Diagram Features of the Console Start the walking belt and adjust the speed HOW to Turn on the PowerHOW to USE the Manual Mode Select the manual modeMonitor your progress with the displays Matrix-When you Change the incline of the treadmill as desiredTime/Incline dis Measure your heart rate if desired HOW to USE a Preset Workout Select a preset workoutPress the Start button to start the workout HOW to USE the Custom Workout Center Select the Custom Workout CenterPress the Start Workout button to start the workout Press the Start Fitness Test button to start the workout HOW to USE the Fitness Test WorkoutPut on the chest pulse sensor Select the fitness test workoutHOW to USE the Sound System HOW to USE AN Ifit Card Insert an iFIT card and select a workoutMonitor your progress with the displays Information Mode HOW to Adjust the Cushioning SystemOptional Chest Pulse Sensor HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USE Problem The power turns off during use TroubleshootingView Page Exercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesSuggested Stretches Key No. Qty Description R0108AQty Exploded Drawing A-Model No. NTL07007.1 Exploded Drawing B-Model No. NTL07007.1 Exploded Drawing C-Model No. NTL07007.1 Exploded Drawing D-Model No. NTL07007.1 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT