NordicTrack NTL19007.0 user manual Problem The walking belt slows when walked on

Page 27

Next, locate the Reed Switch (20) and the Magnet

(12)on the left side of the Pulley (11). Turn the Pulley until the Magnet is aligned with the Reed Switch.

Make sure that the gap between the Magnet and the Reed Switch is about 1/8 in. (3 mm). If neces- sary, loosen the indicated 3/4" Tek Screw (29), move the Reed Switch slightly, and then retighten the Tek Screw. Reattach the Hood (not shown) with the six 3/4" Screws (not shown). Run the treadmill for a few minutes to check for a correct speed reading.

Top

 

View

 

29

1/8 in.

20

11

12

 

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 12.

b. If the walking belt is overtightened, treadmill perfor- mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts counterclockwise, 1/4 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 3 to 4 in. (7 to 10 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few min- utes. Repeat until the walking belt is properly tight- ened.

b

3–4 in.

 

Rear Roller Bolts

c. If the walking belt still slows when walked on, please see the front cover of this manual.

PROBLEM: The walking belt is off-center or slips when walked on

SOLUTION: a. If the walking belt is off-center, remove the key and UNPLUG THE POWER CORD. If the walking belt has shifted to the left, use the hex key to turn the left rear roller bolt clockwise 1/2 of a turn; if the walk- ing belt has shifted to the right, turn the left rear roller bolt counterclockwise 1/2 of a turn. Be careful not to overtighten the walking belt. Plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walking belt is centered.

b.If the walking belt slips when walked on, first remove the key and UNPLUG THE POWER CORD. Using the hex key, turn both rear roller bolts clockwise, 1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each edge of the walking belt 3 to 4 in. (7 to 10 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and carefully walk on the treadmill for a few minutes. Repeat until the walking belt is properly tightened.

a

b

27

Page 26 Page 28
Image 27
Page 26 Page 28
Contents
QUESTIONS? Model No. NTL19007.0 Serial NoCall TOLL-FREE Table of Contents Important Precautions Power Lines Service Before YOU Begin Make sure that the power cord is unplugged AssemblyFul not to pinch the Upright Wire Harness Not tighten the Upright Bolts yetTighten the Upright Bolts yet Wires are pinched Page HOW to Connect AN External Source Using a Catv Cable Chest Pulse Sensor Troubleshooting HOW to USE the Chest Pulse SensorHOW to PUT on the Chest Pulse Sensor Chest Pulse Sensor Care and MaintenanceOperation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Features of the Console Console DiagramHOW to USE the Manual Mode HOW to Turn on the PowerTurn on the fan if desired Select a display mode and follow your progressWith the exercise information on the screen Measure your heart rate if desiredHOW to USE AN Event Training Workout Select an event training workoutPress the Start button to start the workout HOW to USE a Preset Workout Select a preset workoutEnter your weight Select one of the four custom workouts HOW to Create a Custom WorkoutHOW to USE a Custom Workout Insert an iFIT card and select a workout HOW to USE AN Ifit CardSelect one of the four heart rate workouts HOW to USE a Heart Rate WorkoutPress the Volume buttons to adjust the volume HOW to Operate the Personal TelevisionPress the TV button again and add or delete channels Information ModeHOW to Adjust the Cushioning System HOW to USE the Stereo Sound SystemHOW to Lower the Treadmill for USE HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Move the TreadmillProblem The power turns off during use TroubleshootingProblem The walking belt slows when walked on Problem The chest pulse sensor does not function properly Problem Television reception is poorExercise Frequency Exercise GuidelinesExercise Intensity Workout GuidelinesQty Description R1207AQty Description Drawing ExplodedModel No. NTL19007.0 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT