PROBLEM: The displays and indicators on the console remain lit after the key is removed | ||
SOLUTION: a. Hold down the STOP button while inserting the key into the console. |
|
|
a |
| |
Make sure that there is not a letter ÒdÓ in the CALS/FAT CALS |
| |
|
| |
|
| |
display. If a ÒdÓ appears in the display, the console is in the ÒdemoÓ |
|
|
mode. This mode is intended to be used only when a treadmill is dis- |
|
|
played in a store. When the console is in the demo mode, the power |
|
|
cord can be plugged in, the key can be removed from the console, |
|
|
|
| |
and the displays and indicators on the console will automatically light |
|
|
in a preset sequence, although the buttons on the console will not operate. If a ÒdÓ appears in the | ||
CALS/FAT CALS display, press the SPEED Ð button so the display is blank. Then, remove | ||
the key from the console. |
|
|
PROBLEM: The displays of the console do not function properly |
|
|
| |
SOLUTION: a. Remove the key from the console and unplug the | a |
|
| |
power cord. Next, remove the two Short Hood | 118 | 41 | ||
| ||||
Screws (118) from the Motor Hood (62). Pivot the |
|
| ||
|
|
| ||
Uprights (39) in the direction shown by the arrow until |
|
| 39 | |
the handles are resting on the floor. Note: It will be |
|
| ||
easier and safer if two people perform this opera- |
|
|
| |
tion. |
|
|
| |
Locate the two Screws (41) in the space between the |
| 62 |
| |
|
|
| ||
front edge of the Motor Hood (62) and the treadmill. |
|
| 118 | |
Remove the Screws. |
|
|
| |
Return the Uprights (39) to the vertical position. Lift off the Motor Hood (62), being careful not to | ||||
damage the hook and loop fasteners on the front of the belly pan. |
| |||
Locate the Reed Switch (59) and the Magnet (117) on |
|
|
| |
the left side of the Pulley (6). Turn the Pulley until the |
| 1/8Ó |
| |
Magnet is aligned with the Reed Switch. Make sure |
|
| ||
that the gap between the Magnet and the Reed |
| 64 | 6 | |
Switch is about 1/8Ó. If necessary, loosen the Screw |
| 59 | 117 | |
(64) and move the Reed Switch slightly. Retighten the |
| |||
|
|
| ||
Screw. |
| Top |
| |
|
|
| ||
| View |
| ||
|
|
| ||
for a few minutes to check for a correct speed reading. |
|
|
|
30