Life Fitness 90T, 91Ti specification

Position the wax bag under the frame: Place the wax bag (F) on top of the wax tray, so that the wax bag is directly underneath the treadmill motor pan (C), the wax bag flange is facing out toward the front of the treadmill, and the wax bag hose is near the hole (G) at the bottom of the motor pan through which the hose will be fed in the next step.

Connect the wax bag hose to the pump inlet hose: Cut off the end of the wax bag hose (E) one half-inch from the end. Feed the hose through the hole (G) at the bottom of the motor pan, and slide it onto the barbed nozzle on the wax pump inlet hose located inside the motor compart- ment. Be sure to fully seat the wax bag hose onto the inlet hose. Release (2) the hose clamp (D).

CAUTION: Failure to release the hose clamp greatly shortens belt life.

MISE EN GARDE : la bride de serrage doit être relâchée sous peine de réduire de façon importante la durée de vie du tapis.

Close the wax tray: Align two holes of the wax bag flange with the two holes along the front edge of the wax tray (B) and the two holes at the bottom of the treadmill motor pan (C). Attach the wax tray and wax bag (F) to the motor pan with two of the push-rivets (A), simply by pushing each rivet upward through both sets of aligned holes. Once each rivet is pushed through the holes as far as possible, its front tip flares open to keep the tray and wax bag fastened to the motor pan. Push a third push-rivet through the remaining aligned holes in the wax tray and the bottom of the treadmill motor pan.

Inform the system that a new wax bag has been installed: Access the Manager’s Configuration. For details, see Section 5.1, titled Entering and Using the Manager’s Configuration. On the 91Ti model, scroll to the Refill Waxer System configuration setting. Press ENTER. The MESSAGE CENTER displays “REPAIR LOGGED”. Press the CLEAR key three times to exit the Manager’s Configuration. On the 90T model, select the Waxer System Installed configuration setting. Change the setting to “no” by pressing the SPEED DOWN ARROW key once. Then, change the setting to “yes” by pressing the SPEED UP ARROW key once. Press the STOP key once to exit the Manager’s Configuration.

HOW TO POSITION AND STABILIZE THE LIFE FITNESS® TREADMILL

Following all safety instructions in Section 1.1, move the treadmill to the location in which it will be used. See Section 7, titled Specifications, for the dimensions of the footprint. Allow a distance of eight inches, or 21 centimeters, between the treadmill and other units on either side. Allow a distance of six feet, or two meters, from the rear of the treadmill to

any object or surface.

After placing the unit where it will be used, check its stability. If there is even a slight rocking motion or the unit is not stable, determine which stabilizing leg is not resting on the floor. To adjust, loosen the JAM NUT (A), and turn the STABILIZING LEG (B) until the rocking motion ceases, and both sta- bilizing legs rest firmly on the floor. Retighten the JAM NUT.

NOTE: It is extremely important that the stabilizing leg be correctly adjusted for proper opera- tion. An unbalanced unit may cause striding belt misalignment.