Woodstock M1036 owner manual Mounting to Workbench, Mounting Headstock to Column

Page 14

M1036 Micro Mill

Mounting to Workbench

SET UP

Mounting the mill to the workbench provides maximum rigidity and prevents the mill from tipping. Mounting the mill should be done before installing the headstock for the best access to the mounting holes. When choosing a location for the mill, make sure the cross feed and the longitudinal handwheels extend out beyond the edge of the table surface. This will allow unrestricted handwheel operation.

To mount the mill to the workbench, do these steps:

1.Measure the thickness of the workbench and add 11⁄2" to determine the necessary screw length.

2.Mark your hole locations, using the mounting holes in the base as a guide (see Figure 5).

3.Drill 3/16" holes through the workbench.

4.Place a precision level on the mill/drill table and shim the mill/drill until it is level side-to-side and front-to-back.

5.Bolt the mill to the workbench with two 6mm cap screws (length determined in Step 1), hex nuts and flat washers.

Mounting Headstock to

Column

To install the headstock on the column, do these steps:

1.Set the base upright and slide the collar half way down the column.

2.Secure the collar by tightening the cap screw with a 4mm hex wrench, then slide the spacer over the column (see Figure 6).

3.Insert the column lock knob assembly into the head- stock, as shown in Figure 7.

4.Slide the headstock onto the column, line the chuck up with the hole in the base, and lock it in place with the column lock knob.

5.Thread the downfeed lever into the hub and tighten with the included wrench.

-12-

Figure 5. Mounting hole locations.

Figure 6. Collar and spacer installed on

the column.

Figure 7. Installing the column lock knob.

Image 14

Contents Micro Mill Page Contents Maintenance Woodstock Technical Support SpecificationsIntroduction About Your New Micro MillControls and Features M1036 Controls and featuresSafety Standard Safety InstructionsSafety Additional Safety Instructions for Micro Mills Extension Cords Electrical110V Operation GroundingUnpacking SET UPItems Needed for Set Up Bench Mounting Hardware OptionalInventory Box 1 Contents Figure QtyBox 2 Contents Figure Qty Box 1 Tools and Hardware Not Shown QtyMachine Placement Cleaning MachineMounting Headstock to Column To install the headstock on the column, do these stepsMounting to Workbench To mount the mill to the workbench, do these stepsCompound Slide Table To install the compound slide table, do these stepsTo install the vise, do these steps ViseTest Run and Spindle Break-in Table Travel OperationsGeneral Headstock Height Graduated DialsBacklash To use the downfeed lever, do this step Downfeed ControlsDigital Height Gauge To use the micro downfeed handwheel, do these stepsTo set the depth stop, do these steps Depth StopChanging RPM To change the RPM, do these stepsDrill Chuck Removal To install a drill bit, do these stepsDrill Chuck To remove a drill bit, do these stepsCollets To install the collet chuck, do these stepsTo install the collet in the collet chuck, do these steps Table & Base MaintenanceCleaning Lubrication Cross slide and saddle ways Quill shaftGibs ServiceTo adjust the gibs, do these steps Replacing Motor Brushes Fuse ReplacementUnscrew the cap from the motor housing see Figure To replace the motor brushes, do these stepsElectrical Components Troubleshooting Symptom Possible Cause Corrective ActionParts Parts List PART# DescriptionFLATWASHER24MM Warranty Warranty Registration CommentsBOX BELLINGHAM, WA