Woodstock M1036 owner manual Drill Chuck Removal, To install a drill bit, do these steps

Page 21

M1036 Micro Mill

Drill Chuck

The drill chuck will only accept bits with a maximum of 1⁄4" shank. When installing a bit in the drill chuck, make sure it is tight enough that it will not come loose during operation.

To install a drill bit, do these steps:

1.UNPLUG THE MICRO MILL!

2.Open the drill chuck wide enough to accept the shank of the bit.

3.Insert the bit as far as possible into the chuck WITHOUT allowing the chuck jaws to touch the cut- ting edges, and hand tighten the chuck.

Note: Make sure small bits are not trapped between the edges of two jaws; if they are, reinstall the bit or it will not be secure enough to use for drilling.

4.Final tighten the drill chuck with the chuck key.

To remove a drill bit, do these steps:

1.UNPLUG THE MICRO MILL!

2.Use the chuck key to open the drill chuck, and catch the bit with a rag to protect your hands.

Drill Chuck Removal

The drill chuck and the collet chuck are attached to the arbor with a JT1 taper. Matched tapers on the arbor and the inside of the chuck use a friction fit to for a semi-per- manent assembly.

To remove the drill chuck, do these steps:

1.Protect the table surface with a piece of cardboard, or hold the cutter or tool with a shop towel to pre- vent it from falling out of the collet.

2.Place the chuck removal wedge (Figure 21) between the top of the drill chuck and the spindle (see Figure 22), then tap the wedge to separate the chuck from the arbor.

Figure 20. Drill chuck.

Figure 21. Chuck removal wedge.

Figure 22. Drill chuck removal.

OPERATIONS

-19-

Page 20 Page 22
Image 21
Page 20 Page 22
Contents Micro Mill Page Contents Maintenance Introduction SpecificationsWoodstock Technical Support About Your New Micro MillM1036 Controls and features Controls and FeaturesStandard Safety Instructions SafetySafety Additional Safety Instructions for Micro Mills 110V Operation ElectricalExtension Cords GroundingItems Needed for Set Up SET UPUnpacking Bench Mounting Hardware OptionalBox 2 Contents Figure Qty Box 1 Contents Figure QtyInventory Box 1 Tools and Hardware Not Shown QtyCleaning Machine Machine PlacementMounting to Workbench To install the headstock on the column, do these stepsMounting Headstock to Column To mount the mill to the workbench, do these stepsTo install the vise, do these steps To install the compound slide table, do these stepsCompound Slide Table ViseTest Run and Spindle Break-in Operations GeneralTable Travel Graduated Dials BacklashHeadstock Height Digital Height Gauge Downfeed ControlsTo use the downfeed lever, do this step To use the micro downfeed handwheel, do these stepsChanging RPM Depth StopTo set the depth stop, do these steps To change the RPM, do these stepsDrill Chuck To install a drill bit, do these stepsDrill Chuck Removal To remove a drill bit, do these stepsTo install the collet chuck, do these steps To install the collet in the collet chuck, do these stepsCollets Maintenance CleaningTable & Base Cross slide and saddle ways Quill shaft LubricationService To adjust the gibs, do these stepsGibs Unscrew the cap from the motor housing see Figure Fuse ReplacementReplacing Motor Brushes To replace the motor brushes, do these stepsElectrical Components Symptom Possible Cause Corrective Action TroubleshootingParts PART# Description Parts ListFLATWASHER24MM Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA
Top Page Image Contents