Woodstock M1036 owner manual Electrical, 110V Operation, Extension Cords, Grounding

Page 10

M1036 Micro Mill

ELECTRICAL

110V Operation

ELECTRICAL

The SHOP FOX® Model M1036 is prewired for 110 volt operation. The motor supplied with your new Micro Mill is rated at 0.2 HP and will draw approximately 2 amps. A 5-15 plug is included for your machine and is intended to be plugged into a matching 5-15 receptacle.

Connect your machine to a circuit (wire, breaker, plug, receptacle) that is rated for at least 10 amps.

Keep in mind that a circuit being used by other machines or tools at the same time will add to the total load being applied to the circuit. Add up the load ratings

of all machines on the circuit. If the total amp load exceeds the rating of the circuit breaker or fuse, use a different circuit.

Extension Cords

When it is necessary to use an extension cord, use the following guidelines:

•Use cords rated for Standard Service

•Never exceed a length of 100 feet

•Use cords with 16 ga. wire or bigger

•Ensure cord has a ground wire and pin

•Do not use cords in need of repair

Grounding

This machine must be grounded! The electrical cord sup- plied with this machine comes with a grounding pin. Do not remove it. If your outlet does not accommodate a ground pin, have it replaced by a qualified electrician or have an appropriate adapter installed.

Note: When using an adapter, the adapter must be grounded.

Figure 2. Typical 110V 3-prong plug and

outlet.

This equipment must be grounded. Verify that any existing electrical out- let and circuit you intend to plug into is actually grounded. If it is not, it will be necessary to run a separate 12 AWG copper grounding wire from the outlet to a known ground. Under no circum- stances should the grounding pin be removed from any three-pronged plug or serious injury may occur.

-8-

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Micro Mill Page Contents Maintenance Woodstock Technical Support SpecificationsIntroduction About Your New Micro MillControls and Features M1036 Controls and featuresSafety Standard Safety InstructionsSafety Additional Safety Instructions for Micro Mills Extension Cords Electrical110V Operation GroundingUnpacking SET UPItems Needed for Set Up Bench Mounting Hardware OptionalInventory Box 1 Contents Figure QtyBox 2 Contents Figure Qty Box 1 Tools and Hardware Not Shown QtyMachine Placement Cleaning MachineMounting Headstock to Column To install the headstock on the column, do these stepsMounting to Workbench To mount the mill to the workbench, do these stepsCompound Slide Table To install the compound slide table, do these stepsTo install the vise, do these steps ViseTest Run and Spindle Break-in General OperationsTable Travel Backlash Graduated DialsHeadstock Height To use the downfeed lever, do this step Downfeed ControlsDigital Height Gauge To use the micro downfeed handwheel, do these stepsTo set the depth stop, do these steps Depth StopChanging RPM To change the RPM, do these stepsDrill Chuck Removal To install a drill bit, do these stepsDrill Chuck To remove a drill bit, do these stepsTo install the collet in the collet chuck, do these steps To install the collet chuck, do these stepsCollets Cleaning MaintenanceTable & Base Lubrication Cross slide and saddle ways Quill shaftTo adjust the gibs, do these steps ServiceGibs Replacing Motor Brushes Fuse ReplacementUnscrew the cap from the motor housing see Figure To replace the motor brushes, do these stepsElectrical Components Troubleshooting Symptom Possible Cause Corrective ActionParts Parts List PART# DescriptionFLATWASHER24MM Warranty Warranty Registration CommentsBOX BELLINGHAM, WA
Top Page Image Contents