Woodstock M1036 Compound Slide Table, Vise, To install the compound slide table, do these steps

Page 15

M1036 Micro Mill

Compound Slide Table

Installation of the compound slide table is not necessary when using the mill as a drill. The compound slide table can be moved in the X and Y axis for use with milling cutters.

To install the compound slide table, do these steps:

1.Thread the handwheel handles into the handwheels.

2.Remove the fence from the base if installed.

3.Slide the T-bolts into the T-slots and place the compound slide table over the T-bolts, as shown in

Figure 8.

4.Measure at the front and back of the compound slide table as shown in Figure 9 to make sure the compound slide table is parallel to the base.

5.Place washers over the T-bolts and secure the com- pound slide table with the hex nuts.

Vise

To install the vise, do these steps:

1.Slide the T-nuts into the compound slide table.

2.Place the vise on the compound slide table and loosely secure it by threading two M6-1 x 18 cap screws with washers through the vise and into the T- bolts, as shown in Figure 10.

3.Align the vise parallel to the compound slide table and tighten the cap screws.

Figure 8. T-bolt installation.

Figure 9. Aligning the compound slide

table.

SET UP

Figure 10. Securing the vise.

-13-

Image 15

Contents Micro Mill Page Contents Maintenance About Your New Micro Mill SpecificationsIntroduction Woodstock Technical SupportM1036 Controls and features Controls and FeaturesStandard Safety Instructions SafetySafety Additional Safety Instructions for Micro Mills Grounding Electrical110V Operation Extension CordsBench Mounting Hardware Optional SET UPItems Needed for Set Up UnpackingBox 1 Tools and Hardware Not Shown Qty Box 1 Contents Figure QtyBox 2 Contents Figure Qty InventoryCleaning Machine Machine PlacementTo mount the mill to the workbench, do these steps To install the headstock on the column, do these stepsMounting to Workbench Mounting Headstock to ColumnVise To install the compound slide table, do these stepsTo install the vise, do these steps Compound Slide TableTest Run and Spindle Break-in Operations GeneralTable Travel Graduated Dials BacklashHeadstock Height To use the micro downfeed handwheel, do these steps Downfeed ControlsDigital Height Gauge To use the downfeed lever, do this stepTo change the RPM, do these steps Depth StopChanging RPM To set the depth stop, do these stepsTo remove a drill bit, do these steps To install a drill bit, do these stepsDrill Chuck Drill Chuck RemovalTo install the collet chuck, do these steps To install the collet in the collet chuck, do these stepsCollets Maintenance CleaningTable & Base Cross slide and saddle ways Quill shaft LubricationService To adjust the gibs, do these stepsGibs To replace the motor brushes, do these steps Fuse ReplacementUnscrew the cap from the motor housing see Figure Replacing Motor BrushesElectrical Components Symptom Possible Cause Corrective Action TroubleshootingParts PART# Description Parts ListFLATWASHER24MM Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA