Woodstock M1036 Replacing Motor Brushes, Fuse Replacement, To replace the fuse, do these steps

Page 26

M1036 Micro Mill

Replacing Motor Brushes

After some period of time, the carbon brushes on the DC motor will need to be replaced. Always replace the brushes in pairs.

To replace the motor brushes, do these steps:

1.UNPLUG THE MICRO MILL!

2.Remove the lower motor cover (see Figure 31) to expose the motor.

3.Unscrew the cap from the motor housing (see Figure 32).

4.Remove the spring and carbon brush, and replace with a new spring and carbon brush.

5.Screw the cap back into the motor housing.

Fuse Replacement

A fuse is located in the switch housing near the RPM dial.

To replace the fuse, do these steps:

1.Loosen the fuse cap.

2.Remove and replace the fuse from the fuse cradle (see Figure 33).

3.Replace the fuse cap.

Figure 31. Lower motor cover.

Carbon Brush

Cap

Figure 32. Carbon brush removal.

SERVICE

Figure 33. Fuse replacement.

-24-

Image 26

Contents Micro Mill Page Contents Maintenance Woodstock Technical Support SpecificationsIntroduction About Your New Micro MillControls and Features M1036 Controls and featuresSafety Standard Safety InstructionsSafety Additional Safety Instructions for Micro Mills Extension Cords Electrical110V Operation GroundingUnpacking SET UPItems Needed for Set Up Bench Mounting Hardware OptionalInventory Box 1 Contents Figure QtyBox 2 Contents Figure Qty Box 1 Tools and Hardware Not Shown QtyMachine Placement Cleaning MachineMounting Headstock to Column To install the headstock on the column, do these stepsMounting to Workbench To mount the mill to the workbench, do these stepsCompound Slide Table To install the compound slide table, do these stepsTo install the vise, do these steps ViseTest Run and Spindle Break-in Table Travel OperationsGeneral Headstock Height Graduated DialsBacklash To use the downfeed lever, do this step Downfeed ControlsDigital Height Gauge To use the micro downfeed handwheel, do these stepsTo set the depth stop, do these steps Depth StopChanging RPM To change the RPM, do these stepsDrill Chuck Removal To install a drill bit, do these stepsDrill Chuck To remove a drill bit, do these stepsCollets To install the collet chuck, do these stepsTo install the collet in the collet chuck, do these steps Table & Base MaintenanceCleaning Lubrication Cross slide and saddle ways Quill shaftGibs ServiceTo adjust the gibs, do these steps Replacing Motor Brushes Fuse ReplacementUnscrew the cap from the motor housing see Figure To replace the motor brushes, do these stepsElectrical Components Troubleshooting Symptom Possible Cause Corrective ActionParts Parts List PART# DescriptionFLATWASHER24MM Warranty Warranty Registration CommentsBOX BELLINGHAM, WA