Woodstock M1036 Downfeed Controls, Digital Height Gauge, To use the downfeed lever, do this step

Page 19

M1036 Micro Mill

Downfeed Controls

Quill Feed Control

The quill feed is controlled by the downfeed lever shown in Figure 14. The handle allows the mill to operate as a drill.

To use the downfeed lever, do this step:

1.Pull the quill downfeed lever (Figure 14) forward to feed the quill down towards the workpiece. The quill feed handle is spring loaded to assist in return- ing the handle to the upmost vertical position.

Micro Downfeed Knob

The micro downfeed knob is used to accurately control the quill depth (see Figure 15).

To use the micro downfeed handwheel, do these steps:

1.Push the clutch knob (Figure 15) in lightly and rotate the micro downfeed knob until the clutch knob engages the gear.

2.Rotate the micro downfeed knob clockwise to feed the quill down and counterclockwise to raise the quill.

Digital Height Gauge

The digital height gauge (Figure 16) provides accurate height measurements, zeroing at any height, and incremental readout adjustments.

ON/OFF button: Turns the digital height gauge ON or OFF. This gauge does not automatically turn OFF, so the batteries will die if the gauge is left ON.

ZERO button: Returns the digital readout to 0.000 independent of the height of the quill.

MM/IN button: Changes readout from inches to millimeters.

PLUS and MINUS buttons: Adds or subtracts from the number shown on the digital readout. You must hold the button for several seconds before it begins to function.

When the batteries wear out, open the cover shown in Figure 16 and replace the battery.

Downfeed

Lever

Figure 14. Quill downfeed lever.

Micro Downfeed

Knob

Micro Downfeed

Clutch Knob

Figure 15. Micro downfeed controls.

Battery

Cover

Figure 16. Digital height gauge.

OPERATIONS

-17-

Page 18 Page 20
Image 19
Page 18 Page 20
Contents Micro Mill Page Contents Maintenance About Your New Micro Mill SpecificationsIntroduction Woodstock Technical SupportM1036 Controls and features Controls and FeaturesStandard Safety Instructions SafetySafety Additional Safety Instructions for Micro Mills Grounding Electrical110V Operation Extension CordsBench Mounting Hardware Optional SET UPItems Needed for Set Up UnpackingBox 1 Tools and Hardware Not Shown Qty Box 1 Contents Figure QtyBox 2 Contents Figure Qty InventoryCleaning Machine Machine PlacementTo mount the mill to the workbench, do these steps To install the headstock on the column, do these stepsMounting to Workbench Mounting Headstock to ColumnVise To install the compound slide table, do these stepsTo install the vise, do these steps Compound Slide TableTest Run and Spindle Break-in General OperationsTable Travel Backlash Graduated DialsHeadstock Height To use the micro downfeed handwheel, do these steps Downfeed ControlsDigital Height Gauge To use the downfeed lever, do this stepTo change the RPM, do these steps Depth StopChanging RPM To set the depth stop, do these stepsTo remove a drill bit, do these steps To install a drill bit, do these stepsDrill Chuck Drill Chuck RemovalTo install the collet in the collet chuck, do these steps To install the collet chuck, do these stepsCollets Cleaning MaintenanceTable & Base Cross slide and saddle ways Quill shaft LubricationTo adjust the gibs, do these steps ServiceGibs To replace the motor brushes, do these steps Fuse ReplacementUnscrew the cap from the motor housing see Figure Replacing Motor BrushesElectrical Components Symptom Possible Cause Corrective Action TroubleshootingParts PART# Description Parts ListFLATWASHER24MM Warranty Comments Warranty RegistrationBOX BELLINGHAM, WA
Top Page Image Contents