Cybex 445T Treadmill Owner’s Manual
Quick Operation Guide
NOTE: Maximum user weight is 350 lbs. (159 kg).
The following is a quick overview of the operation of the treadmill. For more information read Detailed Operation Guide in this chapter.
1.Place your feet on the two top steps located on each side of the running belt.
!WARNING: Do not stand on the running belt when starting the treadmill. Always place your feet on the two top steps when beginning a workout.
2.Clip the
3.Press any program key or press Quick Start to skip the settings and begin Manual Mode immediately.
4.If you pressed a program key to select a program, you will now be prompted for workout Time, Level and Weight as appropriate. Adjust these settings with the arrows and press Enter to proceed.
5.The treadmill begins a countdown, “3...2...1,” after which it accelerates the belt to
0.5 mph (0.8 kph) (for Manual Mode) or the speed of the program that you selected.
6.Hold the handrails while you step onto the running belt and begin walking.
7.Press the Speed + — keys to change the belt speed at any time. The right display will show the current speed.
8.Press the Incline 
keys to change the incline at any time. The left display will show the current incline on the first press of the key.
9.Press the Pause/Stop key at any time to stop the running belt. Press again to exit to Dormant Mode and return the incline to 0%.
Detailed Operation Guide
NOTE: Maximum user weight is 350 lbs. (158 kg).
1.Plug the treadmill power cord into a power outlet from a grounded, dedicated circuit, rated for one of the following: 115 VAC ±5%, 60 Hz and 20 amps; 220 VAC, 60 Hz, 12 amps or 230 VAC ±5%, 50 Hz and 12 amps.
2.Locate the on/off (I/O) power switch under the right side rails of the treadmill. Toggle it to the on (I) position to supply power to the internal treadmill components and illuminate the control panel.
Operation Page