Cybex International CX-445T manual Regular Maintenance Activities, Cleaning Your Treadmill

Page 41

Cybex 445T Treadmill Owner’s Manual

4 - Preventive Maintenance

Warnings/Cautions

All warnings and cautions listed in this chapter are as follows:

!WARNING: All maintenance activities shall be performed by qualified personnel. Failure to do so could result in serious injury.

!WARNING: To prevent electrical shock, be sure that power is shut off and the treadmill is unplugged from the electrical outlet before performing any cleaning or maintenance procedures.

!WARNING: Keep wet items away from inside parts of the treadmill. Electrical shock could occur even if the treadmill is unplugged. Do not touch components on the lower board. A charge can remain after unplugging the power cord and turning off the treadmill.

Regular Maintenance Activities

!WARNING: All maintenance activities shall be performed by qualified personnel. Failure to do so could result in serious injury.

Preventive maintenance activities must be performed to maintain normal operation of your treadmill. Keeping a log sheet of all maintenance actions will assist you in staying current with all preventive maintenance activities. See Service Schedule located at the end of this chapter.

NOTE: Worn or damaged components shall be replaced immediately or the treadmill removed from service until the repair is made.

NOTE: Cybex is not responsible for performing regular inspection and maintenance actions for your treadmill. Instruct all personnel in equipment inspection and maintenance actions and also in accident reporting/recording. Contact Cybex Customer Service at 800-766-3211 or 508-533-4300 for any preventive maintenance or service concerns.

Cleaning Your Treadmill

When cleaning your treadmill spray a mild cleaning agent, such as a water and dishsoap solution, on a clean cloth first and then wipe the treadmill with the damp cloth.

Preventive

Maintenance

Page 4-1

Image 41
Contents Cybex CX-445T Treadmill FCC Compliance Information About This ManualAugust 24 Declaration of ConformityPage Page Table of Contents Grounding Instructions Important Voltage InformationFacility Safety Precautions Important Safety InstructionsUser Safety Precautions Ensure all User and Facility safety precautions are observed DE-19189-4 DE-19238 DE-16928 DE-19730 IR Comp Adjust Emergency Stop Key e-stop Specifications Technical SpecificationsStop key Terms and Symbols UsedDetailed Operation Guide Quick Operation GuideOperation Stopping the Treadmill Control During Operation Safety SentryData Readouts Displaying Heart Rate Meaning of % Grade Heart Rate ZoneManual Use of ProgramsBase Elevation Speed Interval 1 P-1Peak Elevation Mph GradeSpeed Interval Profiles Show Level 10 at 10 Minutes Speed Interval 2 P-2 Speed Interval Profiles Show Level 10 at 10 Minutes Level 1 2 3 4 5 6 7 8 10% 11% 12% 13% 14% 15% Hill Interval P-3Hill Interval Profiles Show Level 10 at 10 Minutes Pikes Peak P-4 Pikes Peak Profiles Show Level 10 at 13 Minutes Rolling Hills P5 Rolling Hills Profiles Show Level 10 at 10 Minutes Hills P-6 Hills Profiles Show Level 10 at 10 Minutes Base Speed Weight Loss P-7Increased Speed Level Mph GradeWeight Loss Profiles Show Level 10 at 10 Minutes Cardio P-8 Cardio Profiles Show Level 10 at 12 Minutes Cleaning Your Treadmill Regular Maintenance ActivitiesPreventive Maintenance Tension the belt Running Belt MaintenanceTools Required Check the belt and deck condition Disconnect the external power sourceCenter the belt Other Preventive Maintenance Service Schedule Resetting the service odometer Choosing and Preparing a Site Setup and AssemblyAssembling the Treadmill Electrical Power RequirementsUnpack and verify the contents of the boxes NA means Not Applicable Qty Part Number DescriptionHardware Verify the model and voltage Install the upright assemblyLift and move the treadmill Install the console back to the upright assembly Install the console assembly to the console back #16 Attach the motor cover three piecesVisually inspect the treadmill Level your treadmillAttach emergency stop key Testing the Treadmill Operation Setting Operation Options Setup and Assembly Serial Number and Voltage Contacting ServiceDamaged Parts Return Material Authorization RMAOrdering Parts QTY. Part no Description Parts List102 Customer Service Optional Black