Cybex International CX-445T manual Ensure all User and Facility safety precautions are observed

Page 9

Cybex 445T Treadmill Owner’s Manual

Use a dedicated line when operating the treadmill. NOTE: A dedicated line requires one circuit breaker per unit.

Connect the treadmill to a properly grounded outlet only.

DO NOT operate electrically powered treadmills in damp or wet locations.

Keep the running belt clean and dry at all times.

DO NOT leave the treadmill unattended when plugged in and running. NOTE: Before leaving the treadmill unattended, always wait until the treadmill comes to a complete stop and is level. Then, turn all controls to the STOP or OFF position and remove the plug from the outlet. Remove the e-stop key from the treadmill.

Immobilize the treadmill (when not in use) by removing the e-stop key.

Inspect the treadmill for worn or loose components before each use. Do not use until worn or damaged parts are replaced.

Maintain and replace worn parts regularly. Refer to “Preventive Maintenance” section of Owner’s Manual.

DO NOT operate the treadmill if: (1) the cord is damaged; (2) the treadmill is not working properly or (3) if the treadmill has been dropped or damaged. Seek service from a qualified technician.

DO NOT place the cord near heated surfaces or sharp edges.

DO NOT use the treadmill outdoors.

DO NOT operate the treadmill around or where aerosol (spray) or where oxygen products are being used.

Read and understand the Owner’s Manual completely before using the treadmill.

Ensure all users wear proper footwear on or around all Cybex equipment.

Set up and operate the treadmill on a solid, level surface. Do not operate in recessed areas or on plush carpet.

Provide the following clearances: 19.7 inches (0.5 m) at each side, 39 inches (1.0 m) at the back and enough room for safe access and passage at the front of the treadmill. Be sure your treadmill is clear of walls, equipment and other hard surfaces.

DO NOT attempt repairs, electrical or mechanical. Seek qualified repair personnel when servicing. If you live in the USA, contact Cybex Customer Service at 800-766-3211. If you live outside the USA, contact Cybex Customer Service at 508-533-4300.

Use Cybex factory parts when replacing parts on the treadmill.

DO NOT modify the treadmill in any way.

DO NOT use attachments unless recommended for the treadmill by Cybex.

• Ensure all User and Facility safety precautions are observed.

Safety

Page 1-3

 

Image 9
Contents Cybex CX-445T Treadmill FCC Compliance Information About This ManualAugust 24 Declaration of ConformityPage Page Table of Contents Grounding Instructions Important Voltage InformationImportant Safety Instructions User Safety PrecautionsFacility Safety Precautions Ensure all User and Facility safety precautions are observed DE-19189-4 DE-19238 DE-16928 DE-19730 IR Comp Adjust Emergency Stop Key e-stop Specifications Technical SpecificationsStop key Terms and Symbols UsedDetailed Operation Guide Quick Operation GuideOperation Stopping the Treadmill Control During Operation Safety SentryData Readouts Displaying Heart Rate Meaning of % Grade Heart Rate ZoneManual Use of ProgramsBase Elevation Speed Interval 1 P-1Peak Elevation Mph GradeSpeed Interval Profiles Show Level 10 at 10 Minutes Speed Interval 2 P-2 Speed Interval Profiles Show Level 10 at 10 Minutes Level 1 2 3 4 5 6 7 8 10% 11% 12% 13% 14% 15% Hill Interval P-3Hill Interval Profiles Show Level 10 at 10 Minutes Pikes Peak P-4 Pikes Peak Profiles Show Level 10 at 13 Minutes Rolling Hills P5 Rolling Hills Profiles Show Level 10 at 10 Minutes Hills P-6 Hills Profiles Show Level 10 at 10 Minutes Base Speed Weight Loss P-7Increased Speed Level Mph GradeWeight Loss Profiles Show Level 10 at 10 Minutes Cardio P-8 Cardio Profiles Show Level 10 at 12 Minutes Cleaning Your Treadmill Regular Maintenance ActivitiesPreventive Maintenance Running Belt Maintenance Tools RequiredTension the belt Disconnect the external power source Center the beltCheck the belt and deck condition Other Preventive Maintenance Service Schedule Resetting the service odometer Choosing and Preparing a Site Setup and AssemblyElectrical Power Requirements Unpack and verify the contents of the boxesAssembling the Treadmill NA means Not Applicable Qty Part Number DescriptionHardware Install the upright assembly Lift and move the treadmillVerify the model and voltage Install the console back to the upright assembly Install the console assembly to the console back #16 Attach the motor cover three piecesLevel your treadmill Attach emergency stop keyVisually inspect the treadmill Testing the Treadmill Operation Setting Operation Options Setup and Assembly Serial Number and Voltage Contacting ServiceDamaged Parts Return Material Authorization RMAOrdering Parts QTY. Part no Description Parts List102 Customer Service Optional Black