SETTING UP
1. Lift up the front end and move the unit by rolling it on its wheels.
Notes
T Do not move the unit while holding the handle.
T Do not move the unit the cavity below the front section. The cavity is not a handle.
T Do not step on the power plug while moving the unit.
T Slowly lift and move the unit while taking care not to injure your lower back.
Wheels
2. Lay out the supplied mat and place the unit on the mat.
* Lay out the mat so that the rubber surface faces down.
TWhen laying out the mat, a space of 31.5 in. (80 cm) to the left and to the right and 23.6 in. (60 cm) to the front and to the rear of the mat is required.
(see illustration)
Notes
TWhen using the unit on carpet, marks may remain on the carpet even if the unit was first placed on the mat.
23.6"
(60cm)
31.5" (80cm)
TIf there is concern about vibration or noise downstairs, lay out a thick mat that is commercially available.
23.6"
31.5"
(80cm)
T Be sure to place the unit on the mat before |
use. |
- Using the unit without the mat may result in |
scratches on the floor. |
(60cm)
Mat
6