Sears 831.159460 user manual Cable Assembly

CABLE ASSEMBLY

15.Route the Long Cable (23) around the “V”- Pulley (6) on the Right Arm (48). Be sure that the Cable is in the groove of the “V”- Pulley and that the Long Cable Trap (50) is turned to hold the Cable in place. Tighten the 3/8” x 2 1/2” Bolt (7) and the 3/8” Nylon Locknut (not shown).

16.Route the Long Cable (23) around the 3 1/2” Pulley (15) attached to the Pulley Bracket

(20).Be sure that the Cable is in the groove of the Pulley and that the Cable Trap (66) is turned to hold the Cable in place. Tighten the 3/8” x 2” Bolt (12) and the 3/8” Nylon Locknut (not shown).

Make sure that the 5/16” x 5” Bolt (68) is properly tightened and that the Pulley Bracket

(20)can move freely.

17.See the inset drawing. Attach a 3 1/2” Pulley

(15)and a Cable Trap (66) to the indicated hole in the Long “U”-Bracket (57) with a 3/8” x 2” Bolt (12) and a 3/8” Nylon Locknut (21). Be sure that the Cable Trap is inside the “U”- Bracket. Note: This may come pre-assem- bled.

Route the Long Cable (23) around the 3 1/2” Pulley (15) and through the Long “U”-Bracket (57). Be sure that the Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.

18.Note: The Pulley in this drawing is pre- assembled. It is shown disassembled for easy part identification.

Route the Long Cable (23) around the 3 1/2” Pulley (15) attached to the bracket on the Top Frame (55). Tighten the 3/8” x 2” Bolt (12) and the 3/8” Nylon Locknut (21). Be sure that the

Cable is in the groove of the Pulley and that the Cable and Pulley move smoothly.

15
	50
		7
			6

48 23

16 68 66

20

12

15

23

17

23

23

15

66

12

21

57

18		15
	23

Bracket 12

55

21

10