8.Wet the handle of one Press Arm (46) with soapy water. Slide a Hand Grip (31) onto the handle. Press a 1” Round Inner Cap (49) into the other end of the handle. Press a 1 3/4” Square Inner Cap (44) into the Press Arm.
Attach the Press Arm (46) to one side of the Press Frame (17) with two 5/16” x 2 1/2” Bolts (22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the same manner.
9.Identify the Right Arm (48) and the Left Arm (47). Note the position of the welded brack- et on each Arm. Arm identification is very important for step 10.
8 |
| 44 |
|
| 49 |
|
| 31 |
| 44 |
|
| 49 | 46 |
|
| |
|
| 22 |
46 | 3 |
17
9 | 7 |
| 50 |
| 6 |
| 50 |
Attach a
(50) to the Right Arm (48) with a 3/8” x 2 1/2” |
6
Welded
Brackets
47
ARM ASSEMBLY
Bolt (7) and a 3/8” Nylon Locknut (21). |
Attach a
(50) to the Left Arm (47) in the same manner.
10.Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right Arm with the Left Arm (47); refer to step 9 to identify the Right Arm. Be sure that the upper end of the Right Arm is behind the indicated bracket on the Top Frame (55).
Tap two 1” Retainers (69) and a 1” Round Cover Cap (70) onto the right axle. Be sure that the teeth on the Retainers bend toward the Cover Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the lower ends of the Right and Left Arms (47, 48). Wet the lower end of each Arm with soapy water. Slide a 10” Pad (45) onto the lower end of each Arm.
21
48
10 | 55 |
| |
| 47 |
Bracket
Lubricate Axle
48 | 69 |
70 45
44
55
45
69
70 |
8