ASSEMBLY
Assembly requires two people. |
| Place all parts of the elliptical crosstrainer in a cleared area and remove the | |
packing materials. Do not dispose of the packing materials until assembly is completed. | In addition to the two | ||
included allen wrenches, assembly requires a phillips screwdriver | , an adjustable | ||
wrench | , a rubber mallet | , and pliers | . |
As you assemble the elliptical crosstrainer, use the drawings below to identify the small parts used in assembly.
The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on
page 22. The | second number refers to the quantity used in | assembly. | Note: Some small parts may have been |
shipping. If a part is not in the parts bag, check to | see if it has been |
|
M8 x 19mm | M10 x 25mm | M8 Split | M10 Split | M8 Washer | M10 Washer | |
Screw | Screw | Washer | Washer | |||
M10 x 43mm Screw | M10 x 56mm Screw | M10 x 33mm Carriage Bolt | ||||
1. Identify the Rear Stabilizer (59), which has Leveling | 1 |
| 60 | |||
Feet (14) threaded into it. Attach the Rear Stabilizer to | 60 | |||||
| 22 | |||||
the Frame with the four M10 x 56mm Screws (60) and |
| |||||
|
| |||||
four M10 Split Washers (22). |
|
|
|
| ||
|
|
|
|
| 1 | |
|
|
|
| 22 | 59 | |
|
|
|
|
| ||
|
|
|
|
| 14 | |
2. Attach the Front Stabilizer (90) to the Frame (1) with | 2 |
| 65 | |||
the four M10 x 43mm Screws (65) and four M10 Split |
| |||||
|
|
| ||||
Washers (22). Make sure that the Front Stabilizer is |
|
| 22 | |||
turned so the Wheels (45) are not touching the |
|
|
|
| ||
floor. |
|
|
| 65 |
| |
|
|
|
|
| ||
|
|
|
| 22 | 1 | |
|
|
| 45 |
|
| |
|
|
|
|
| 90 | |
|
|
| 5 |
|
|