NordicTrack NTL19806.0 user manual Problem Television reception is poor

Page 28

PROBLEM: The incline of the treadmill does not change correctly

SOLUTION: a. With the key in the console, press one of the Incline buttons. While the incline is changing, re- move the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level. This will recalibrate the incline system.

PROBLEM: Television reception is poor

SOLUTION: a. For the television to operate properly, good reception is necessary. If you are using an antenna, make sure that it is properly connected and adjusted for optimal reception. (See HOW TO CON- NECT AN ANTENNA on page 11.)

b. Check for the problems listed below and follow the applicable instructions.

Ignition (black spots or horizontal streaks that appear or a picture that flutters or drifts)—Usually this is caused by interference from automobile ignition systems, neon lamps, electric drifts, or other electric appliances. Try changing the position of the treadmill or other electric appliances to correct the problem.

Ghosts—Ghosts are caused by the television signal following two paths—one is the direct path and the other is reflected from tall buildings, hills, or other objects. Change the direction or posi- tion of the antenna to improve reception.

Blue Screen—If the treadmill is located in the fringe area of a television station where the signal is weak, the picture may be of poor quality or a blue screen may appear. If the signal is weak, it may be necessary to install an external antenna to improve the picture.

Note: If one of these symptoms appears when the cable from a CATV company is connected, the symptom may be caused by the local company broadcast.

PROBLEM: The chest pulse sensor does not function properly

SOLUTION: a. If the chest pulse sensor does not function properly, see CHEST PULSE SENSOR TROU- BLESHOOTING on page 12.

b. If the chest pulse sensor still does not function properly, the battery should be changed. To replace the battery, locate the battery cover on the back of the sensor unit. Insert a coin into the slot in the cover and turn the cover counterclockwise to the “open” position. Remove the cover.

b

Battery Cover

Remove the old battery from the sensor unit. Insert a new CR 2032 battery, making sure that the writing is on top. In addition, make sure that the rubber gasket is in place in the sensor unit. Replace the bat- tery cover and turn it to the closed position.

Battery

Cover

Battery

Rubber

Gasket

28

Image 28 Contents
Model No. NTL19806.0 Serial No QUESTIONS?Call TOLL-FREE Table of Contents Important Precautions Page Power Lines Before YOU Begin Assembly Ful not to pinch the Upright Wire Harness Make sure that no wires are pinched Page HOW to Connect AN Antenna HOW to Connect a 75 OHM Catv CableHOW to Connect a VCR HOW to Connect a DVD Player or VCRHOW to USE the Chest Pulse Sensor HOW to PUT on the Chest Pulse SensorChest Pulse Sensor Troubleshooting Chest Pulse Sensor Care and MaintenanceHOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt Console Diagram Features of the ConsoleHOW to Turn on the Power HOW to USE the Manual Mode Select the manual modeStart the walking belt and adjust the speed Change the incline of the treadmill as desiredTurn on the fan if desired Measure your heart rate if desiredWhenkey. you are finished exercising, remove Select an event training program HOW to USE AN Event Training ProgramPress the Start button to start the program Select a preset program HOW to USE a Preset ProgramEnter your weight HOW to Create a Custom Program Select one of the four custom programsHOW to USE a Custom Program HOW to USE a Heart Rate Program HOW to Operate the Personal Television Press the Volume buttons to adjust the volumeHOW to USE the Stereo Sound System Press the Channel buttons to select Desired channelHOW to USE the Information Mode Press the TV button again and add or delete Channels HOW to Adjust the Cushioning System HOW to Fold and Move the Treadmill HOW to Fold the Treadmill for StorageHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useProblem The walking belt slows when walked on Problem Television reception is poor Problem The chest pulse sensor does not function properlyConditioning Guidelines Exercise IntensityWorkout Guidelines Exercise FrequencyR1006A Qty DescriptionOrdering Replacement Parts Model No. NTL19806.0 No. NTL19806.0 Limited Warranty