3.Attach the Front Leg (3) to the Bench Frame (1) with two M10 x 100mm Screws (117) and two
M10 Washers (148). Tighten the Screws used in steps 1 and 3.
4.Attach the Backrest (32) and the Headrest (99) to the Backrest Frame (8) with six M6 x 20mm Screws (122).
3 |
|
|
| 148 |
|
117 |
| 1 |
| 3 |
|
4 |
| 99 |
| 32 | |
|
|
8
122 122
122
5.Attach the Backrest Support Spacer (51) between the two Backrest Supports (7) with an M10 x 165mm Bolt (123), two M10 Washers (148), and an M10 Nylon Locknut (153). Do not tighten the
Nylon Locknut yet.
Orient the Backrest Supports (7) so that the Backrest Support Spacer (51) is closer to the upper ends.
Apply some of the included grease to an M10 x 165mm Bolt (123). Attach the Backrest Frame (8) and two Backrest Bushings (48) between the Backrest Supports with the Bolt, two M10 Washers (148), and an M10 Nylon Locknut (153).
Do not overtighten the Nylon Locknut; the Backrest Supports must pivot easily.
5
| 48 Opening |
|
|
|
|
|
|
| Opening |
| 8 |
| 48 | |
|
|
|
| |
153 148 |
|
|
| |
153 | 7 |
|
|
|
|
|
|
| |
148 |
| 51 | 7 | |
|
| |||
| Upper |
|
| |
|
|
|
| |
| Ends | 148 |
| 148 |
|
|
| 123 | |
|
| Grease |
| |
|
|
| 123 | |
8