Tubes on the Ramp 3 with the Ramp Spacers

2.Identify the Pivot Axle (14), which is the longest axle. Slide a Ramp Cover (48) onto an M6 x 16mm Patch

Screw (76) as shown. Tighten the Patch Screw into

one end of the Pivot Axle. Apply a small amount of the included grease to the Pivot Axle.

Have a second person hold the two Ramp Spacers

(99)against the sides of the Frame (1) so they cover the indicated tubes on the Frame. Align the round

tubes on the Ramp (3) with the Ramp Spacers;		make
sure that the Ramp is turned as shown in drawing
3 below.	Insert the Pivot Axle (14) into the Ramp, the

Ramp Spacers, and the Frame. If necessary, tap the

Pivot Axle with a rubber mallet to insert it.

Slide the other Ramp Cover (48) onto an M6 x 16mm Patch Screw (76) as shown. Tighten the Patch Screw into the open end of the Pivot Axle (14).

3.Slide an M6 Washer (64) onto an M6 x 16mm Patch Screw (76). Tighten the Patch Screw into one end of the Incline Axle (13). Apply a small amount of grease to the Incline Axle.

Raise the Ramp (3). Insert the Incline Axle (13) into the welded tube under one side of the Ramp, through the motor screw, and then into the welded tube under

the other side of the Ramp. As you insert the Incline

Axle through the motor screw, make sure that the motor screw does not turn.

Slide an M6 Washer (64) onto an M6 x 16mm Patch Screw (76). Tighten the Patch Screw into the open end of the Incline Axle (13).

4.Have another person hold the Upright (2) in the posi- tion shown. Make sure that the Upright is turned as shown in drawing 7 on page 8.

Connect the Upper Wire Harness (95) to the Lower


Wire Harness (42).		Carefully pull	the upper end of
the Upper Wire Harness to remove the slack			from
the Wire Harnesses.		Slide the Upright (2) onto the
Frame (1).	Be careful to avoid disconnecting or
pinching the Wire Harnesses.			Attach the Upright with

three M10 x 25mm Button Screws (114) and three M10 Split Washers (57).

2
			Tubes	48	76
	3
Grease
				99
48
76	14	99	Tubes	1
76				1
3
				Motor
				Screw
					76
	3			64
	3
Grease
	13
76	64
76
4	2		114
			114

	57		57
	114		114
			114
			95
			42
			1

Have a second person hold the two Ramp Spacers

tubes on the Ramp (3) with the Ramp Spacers;

3 below.

the other side of the Ramp. As you insert the Incline

Wire Harness (42).

the upper end of

from

Frame (1).

Be careful to avoid disconnecting or