Healthrider HREL50020 manual

1.Identify the Rear Stabilizer (59), which has Wheels (45) attached to it.

Attach the Rear Stabilizer (59) to the rear of the Frame

(1)with the two M10 x 105mm Carriage Bolts (60) and two M10 Nylon Locknuts (26). Make sure that the

Rear Stabilizer is turned so the Wheels (45) are not touching the floor.

2.Attach the Front Stabilizer (14) to the front of the Frame (1) with the two M10 x 92mm Carriage Bolts

(86)and two M10 Nylon Locknuts (26).

3.Slide an M8 Split Washer (58) and an M8 Washer (33) onto an M8 x 19mm Screw (30). Tighten the Screw into one end of an Incline Axle (29). Apply a small amount of the included grease to the Incline Axle.

Align the indicated tubes on the Incline Ramp (5) with the tubes on the Frame (1). Make sure that the

Incline Ramp is turned so the V-shaped grooves are on top. Insert the Incline Axle (29) into the Incline Ramp and the Frame. Note: It may be helpful to tap the Incline Axle with a rubber mallet to insert it.

Slide an M8 Split Washer (58) and an M8 Washer (33) onto an M8 x 19mm Screw (30). Tighten the Screw into the open end of the Incline Axle (29).

4.Slide an M8 Split Washer (58) and an M8 Washer (33) onto an M8 x 19mm Screw (30). Tighten the Screw into one end of the other Incline Axle (29). Apply a small amount of grease to the Incline Axle.

Lift the Incline Ramp (5). Insert the Incline Axle (29) through one side of the Incline Ramp, through a 57mm Spacer (22), through the motor screw, through another 57mm Spacer (22), and then through the other side of the Incline Ramp.

Slide an M8 Split Washer (58) and an M8 Washer (33) onto an M8 x 19mm Screw (30). Tighten the Screw into the open end of the Incline Axle (29).

1
			26	59
	26
	1				45
				60
2	86	14
					26
			1
			26
3
			V-shaped Groove
				5
					33 58
					30
	Grease		29		Tubes
	33
	58
	30		1
			Tubes
4
			22	33	58
					30
	29		Motor
	33		Screw		5
	58
	30	Grease

6